Results 191 to 200 of about 3,503,812 (286)

Ti3C2Tx MXene/Silver Composite Foams For Lightweight, High‐Performance Electromagnetic Interference Shielding and Joule Heating

open access: yesAdvanced Materials Interfaces, EarlyView.
Ultrathin MXene/EMF composite foams achieve a specific shielding efficiency of 749.6 dB.dB·cm3$\mathrm{dB}\cdot {\mathrm{cm}}^{3}$/g, while the silver‐enhanced MXene/Ag/EMF reaches 81.4 dB shielding effectiveness at just 1.0 mm thickness. Both composites exhibit rapid Joule heating, retain stability up to 250∘C$^\circ{\rm C}$, and withstand 1000 ...
Abdullah A. Mahmood   +7 more
wiley   +1 more source

A Single‐Solvent Acetone Strategy for Surface Enhancement and Robust Bonding in PMMA Microfluidic Devices

open access: yesAdvanced Materials Interfaces, EarlyView.
A single‐solvent acetone strategy simultaneously restores laser‐ablated PMMA surfaces and enables high‐strength bonding for microfluidic device fabrication. The process produces smooth, optically clear channels, achieves bonding strengths up to 27.3 MPa, and forms leak‐free devices within 25 min, providing a rapid and accessible route to robust PMMA ...
Sadık Koç, H. Cumhur Tekin
wiley   +1 more source

Invasive songbirds show greater heat, but not cold, tolerance than Mediterranean native counterparts. [PDF]

open access: yesJ Exp Biol
García López de Haro E   +6 more
europepmc   +1 more source

UCST‐Responsive PMEGA: From Solution Behavior to Functional Hydrogel Surfaces

open access: yesAdvanced Materials Interfaces, EarlyView.
PMEGA is used as a versatile water‐based UCST‐responsive platform for engineering microstructured hydrogel coatings via a thiol–ene CLAG approach. From PMEGAs of well‐defined UCST properties, the UV‐based CLAG method provides precise control over film thickness, ranging from nanometers to micrometers, and enables high‐resolution patterning.
Thi Phuong Thu Nguyen   +4 more
wiley   +1 more source

Large‐Scale and Cost‐Effective Fabrication of Ultra‐Thin, Biodegradable Microelectrode Arrays and Pressure Sensors Using Laser Micromachining

open access: yesAdvanced Materials Technologies, EarlyView.
A mask‐free and cost‐effective UV‐pico‐second laser‐based microfabrication method is proposed to fabricate large‐area biodegradable microelectrode arrays and pressure sensors. These devices demonstrate low impedance, good conformability, excellent biocompatibility, and rapid degradation, providing a new route for next‐generation transient electronics ...
Bhavani Prasad Yalagala   +5 more
wiley   +1 more source

Flexible Pressure Sensor With Co‐Optimized Sensitivity and Linearity Based on Gradient Toroidal Microstructures

open access: yesAdvanced Materials Technologies, EarlyView.
A flexible piezoresistive pressure sensor with gradient toroidal CNT/PDMS microstructures is reported. The hierarchical geometry enables sequential electrode contact, achieving a sensitivity of 256.20 kPa−1 and linear response (R2 = 0.99) over 0–1000 kPa.
Rongmei Wang   +8 more
wiley   +1 more source

Home - About - Disclaimer - Privacy