Results 231 to 240 of about 121,753 (310)

Compressible direct numerical simulation of low-pressure turbines: part II - effect of inflow disturbances

, 2014
Michelassi, V., Pichler, R., Chen, L., Sandberg, R.D.   +3 more
core   +1 more source

Instability Characteristics and Control of Steel Arch-Concrete Supported Deep Drifts under High In Situ Stress. [PDF]

ACS Omega
Qin S, Zhao X, Ma S, Song J, Wang Y, Liu S.   +5 more
europepmc   +1 more source

Grain Refinement During Severe Plastic Deformation and Similitude of Subgrain Formation: A Molecular Dynamics Study

Advanced Engineering Materials, EarlyView.
Molecular dynamics is used to investigate structure refinement during severe plastic deformation. The results show similitude with experimental data. Molecular dynamics simulations of severe plastic deformation of monocrystalline and polycrystalline samples by multiaxial compression of aluminum are carried out.
Roberto B. Figueiredo
wiley   +1 more source

Numerical Simulation Study on the Through-Layer Propagation Law of Hydraulic Fracturing in Highly Deviated Wells in Offshore Multilayer Gently Dipping Formations. [PDF]

ACS Omega
Guo B, Xu Y, Qu X, Li X, Liang S, Sun S, Li X, Wang X, Niu Z.   +8 more
europepmc   +1 more source

Triple Junctions as Dislocation‐Like Defects: The Role of Grain Boundary Crystallography Revealed by Experiment and Atomistic Simulation

Advanced Engineering Materials, EarlyView.
Grain boundary triple junctions are an essential ingredient of the microstructure of polycrystalline materials. In this study, a triple junction is observed using atomic‐resolution scanning transmission electron microscopy and characterized. Computer simulations reveal that the junction has a dislocation character that is determined by the joining ...
Tobias Brink, Saba Saood, Peter Schweizer, Jörg Neugebauer, Gerhard Dehm   +4 more
wiley   +1 more source

Advanced Electron Microscopy and Microcomputed Tomography Analysis of Single‐Crystal Ni‐Base Superalloys After Short‐Term Multiaxial Creep

Advanced Engineering Materials, EarlyView.
This work studies the anisotropic behavior of circular notched tensile specimens of Ni‐base superalloy single crystals during high‐temperature tensile creep along [001], [110], and [111]. Correlative scale‐bridging imaging of specimens reveals early rupture along [110] because 1) plastic deformation proceeds faster at notch center; 2) more (brittle ...
Leonardo Agudo Jácome, Lijie Cao, Christoph Somsen, Johannes Boes, René Hesse, Werner Theisen, Gunther Eggeler   +6 more
wiley   +1 more source

Multiphysics Investigation on Thermal Characteristics of Internal Bio-Inspired V-Ribbed Cooling Channels for Outer Rotor PMSM. [PDF]

Biomimetics (Basel)
Xiong X, Li X, You S, Zhu B, Ding P, Gao H, Hou Z.   +6 more
europepmc   +1 more source

Defect Evolution and Mechanical Performance of Fused Filament Fabrication‐Manufactured 17‐4PH Stainless Steel Revealed by X‐Ray Computed Tomography

Advanced Engineering Materials, EarlyView.
X‐ray computed tomography reveals how process‐induced defects evolve from green to sintered states in Fused Filament Fabrication (FFF)‐manufactured 17‐4PH stainless steel. Internal porosity, weakest cross‐sections, and fracture locations show strong correlation with tensile performance, demonstrating the potential of computed tomography (CT)‐based ...
György Ledniczky, Márk Sárközi, Ibolya Zsoldos, Zoltán Weltsch   +3 more
wiley   +1 more source

Active Corrosion Protection of Sintered AA7075 Aluminum Alloy via Mn Powder Addition

Advanced Engineering Materials, EarlyView.
AA7075 containing Mn‐rich particles is fabricated via spark plasma sintering using AA7075 and Mn powders. Corrosion resistance is evaluated through dip‐and‐dry tests using 0.1 M NaCl (pH 6.0), and mass loss decreases with increasing Mn addition. Mn‐rich particles function as a source of Mn ions, and formation of Mn‐accumulation films on Cu‐containing ...
Ko Ebina, Masashi Nishimoto, Izumi Muto
wiley   +1 more source

Determination of Johnson-Cook Constitutive and Failure Parameters for Cr20Ni80 Alloy Using an Experimental-Numerical Approach. [PDF]

Materials (Basel)
Li Z, Yang X, Zhou K, Song S, Cao M, Li R.   +5 more
europepmc   +1 more source