Results 171 to 180 of about 2,229,474 (385)
Impact of Surface Roughness on the Yield Drop of Hot‐Rolled AZX311 Mg Alloy
Advanced Engineering Materials, EarlyView.Rough‐surfaced AZX311 Mg alloy samples have significantly lower yield strength than polished ones due to stress concentrators forming at V‐notch irregularities. Surface profilometry confirms higher Ra values for rough samples. Highest hardness values were observed near scratched surfaces, indicating strain localization effects near the rough surface ...
Hafiz Muhammad Rehan Tariq +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Additive manufacturing is a promising route for the production of Ni‐base superalloys for turbine applications, such as Inconel 718. Nonetheless, it induces various changes in the microstructure and performance of these materials. One such change is the incidence of the δ‐Ni3Nb phase, whose impact on microstructure, aging precipitate fractions, and ...
Guilherme Maziero Volpato +8 more
wiley +1 more source
Enhanced Electrochemical Properties of Biobased Activated Carbon for Supercapacitors
Advanced Engineering Materials, EarlyView.Biobased activated carbons with diverse properties (pore size distribution, electrical conductivity, capacitance) for supercapacitors applications are synthesized and tested, using renewable biomass as versatile raw materials with disparate inherent heteroatom and molecular building blocks.
Shengfei Zhou +4 more
wiley +1 more source
ON THE FORCIBLE DISCHARGE OF SPORES OF LEPTOSPHÆRIA ACUTA [PDF]
, 1917 William J. Hodgetts
openalex +1 more source
Advanced Engineering Materials, EarlyView.Combining supercritical CO2 (s‐CO2) cycles with particle‐based heat transfer media holds great potential in concentrated solar power plants but poses enormous material challenges. The particle/s‐CO2 heat exchanger must withstand extreme conditions, including high temperatures, pressures, CO2 corrosion, and erosion.
Mathias Christian Galetz +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study explores the energy conversion in powder bed fusion of polymers using laser beam for polyamide 12 and polypropylene powders. It combines material and process data, using dimensionless parameters and numerical models, to enable the prediction of suitable printing parameters.
Christian Schlör +9 more
wiley +1 more source
Revista Ingenierías Universidad de Medellín, 2012 En este artículo se analizaron series de tiempo mensuales de precipitación (mm), caudal (m³/s) y exportación de sedimentos (kton/día) en cuencas de la vertiente oriental del golfo de Urabá.
Andrea Arroyave-Rincón +2 more
doaj