Results 121 to 130 of about 9,420,307 (342)
Hydrogen‐Assisted Fracture of Iron‐Based Fe–Ni–Al Alloys
Advanced Engineering Materials, EarlyView.Principal relations and fracture mechanisms of single‐phase and precipitate‐strengthened Fe–Ni–Al alloys subjected to prior electrochemical hydrogen charging are identified. The mechanisms of hydrogen effect on strength and microhardness are discussed, including hydrogen‐induced increase in microhardness and the role of hydrogen in fracture behavior ...
Nataliya Yadzhak +3 more
wiley +1 more source
Response of lead-acid batteries to chopper-controlled discharge: Preliminary results [PDF]
The preliminary results of simulated electric vehicle, chopper, speed controller discharge of a battery show energy output losses up to 25 percent compared to constant current discharges at the same average discharge current of 100 amperes.
Cataldo, R. L.
core +1 more source
Creep Properties and Deformation Mechanism of Additively Manufactured NiAl‐CrMo Composites
Advanced Engineering Materials, EarlyView.Additively manufactured NiAl‐CrMo composites contain numerous interfaces and cell boundaries that control their creep response. At 700°C under high applied stress, creep is dominated by dislocation‐controlled power‐law mechanisms. At 800°C–900°C and lower stresses, creep is primarily diffusion‐controlled along cell boundaries.
Jan Vollhüter +9 more
wiley +1 more source
Temperature-controlled microwave electrodeless discharge lamps
, 1976 Imperial Users ...
Bartley, David Francis +1 more
openaire +1 more source
????????? ??????-?????? ???????????? ?????? ?????? ????????? ????????? [PDF]
, 2018 Department of Energy Engineering (Battery Science and Technology)Aprotic electrolyte based lithium-oxygen batteries are of considerable interest due to its ultrahigh theoretical specific energy density (1675 mAh per gram of oxygen) against the present ...
Cha, Aming
core
Advanced Engineering Materials, EarlyView.Viktoriia Shtefan, Thorgund Nemec, Ute Hempel, Annett Gebert and coworkers demonstrate that anodic treatment of Ti–Cu‐based metallic glass in a nontoxic pyrophosphate electrolyte forms a protective bilayered Ti/Zr‐oxide film enriched with Cu nanocrystals.
Viktoriia Shtefan +8 more
wiley +1 more source
Nanoparticle synthesis in pulsed low temperature discharges [PDF]
, 1996 Silicon nitride powders with an average size as low as 7 nm are synthesized in a pulsed radio frequency glow discharge. The as-synthesized silicon nitride powder from a silane/ammonia plasma has a high hydrogen content and is sensitive to oxidation in air.
openaire +2 more sources
Assesing the hydrogeological functioning of an evaporite karst system coupling tritium and physicochemical data [PDF]
, 2019 Discharge rate, electrical conductivity and water temperature have been continuously recorded in an evaporite karst spring located in S Spain and 3H determinations of spring water were performed.
Andreo-Navarro, Bartolome +3 more
core
Advanced Engineering Materials, EarlyView.This plot compares experimental tensile stress–strain curves (with 4 different strain rates) and corresponding modelled curves (obtained using the optimised sets of Voce and Miller–Norton parameter values shown). The inferred M‐N values, characterizing the creep, are very similar to those obtained via conventional creep testing.
S. Ooi, R. P. Thompson, T. W. Clyne
wiley +1 more source
Case Studies in Thermal EngineeringTo improve the thermal management and temperature uniformity of lithium-ion batteries, this study proposes and evaluates a novel liquid cooling plate structure featuring gradient porous metal foam (GPFM).
Wenhao Li +3 more
doaj +1 more source