Results 91 to 100 of about 1,449 (203)

Increased Endurance of Nonvolatile Photonics Enabled by Nanostructured Phase‐Change Materials

Advanced Materials, Volume 38, Issue 31, 2 June 2026.
Tapered and segmented islands of the phase‐change material (PCM) antimony selenide (Sb2Se3) integrated on silicon microring resonators enable ultra‐low‐loss, high‐endurance, non‐volatile photonic tuning. The nanostructured PCM design suppresses interfacial scattering and thermal stress, achieving record endurance over 100 million electrical switching ...
Jayita Dutta, Andrew Tang, Brian Mills, Rui Chen, Arnab Manna, Gokul Nath SJ, Virat Tara, Dennis Callahan, Cosmin Constantin Popescu, Juejun Hu, Arka Majumdar   +10 more
wiley   +1 more source

Topological Point Defects in SmC* Liquid Crystals Under Mechanical Disturbance

Advanced Materials Interfaces, Volume 13, Issue 11, 9 June 2026.
Tangetial air jet shear inducess island formation and nucleates topological point defects in uniform SmC films. Island bounded by edge dislocation loops shrink and transform into isolated point defects under continued shear. Mechanical perturbatio provides a controllable route for defect engineering in smectric liquid crystal thin films.
Gunganist Kongklad, Vandana Molahalli, Apichart Pattanaporkratana, Nattaporn Chattham   +3 more
wiley   +1 more source

M3D‐DPWM strategy for three‐phase four‐leg inverter with higher harmonic suppression capability

IET Power Electronics
Three‐phase four‐leg inverters are widely used in power systems due to their inherent ability to handle unbalanced loads. However, with conventional 3D space vector pulse width modulation (3D‐SVPWM), high harmonics of large amplitude exist in the output ...
Ning Li, Panpan Shen, Jie Li, Jiale Hu, Changjie Zhang   +4 more
doaj   +1 more source

Graphene‐Based Wearable Textile Triboelectric Nanogenerators and Biomechanical Sensors

Advanced Materials Technologies, Volume 11, Issue 12, 18 June 2026.
This study presents a wearable textile‐based triboelectric nanogenerator (T‐TENG) using sprayed graphene enhanced with a PVA adhesion layer. The graphene‐based electrode demonstrates high electrical conductivity and robustness to multiple bends. The fabricated T‐TENG provides stable and efficient output, with strong responsiveness to biomotion.
Hongyang Dang, Benji Fenech‐Salerno, Antonio Alessio Leonardi, Federico La Barbera, Felice Torrisi   +4 more
wiley   +1 more source

Comparative Analysis of Space Vector Pulse-Width Modulation Techniques of Three-Phase Inverter to Minimize Common Mode Voltage and/or Switching Losses

Mathematics
Inverter-based systems encounter significant challenges in mitigating common-mode voltage (CMV) and minimizing inverter losses. Despite various space vector pulse-width modulation (SVPWM) techniques proposed to address these issues, a comprehensive ...
Kotb B. Tawfiq, Peter Sergeant, Arafa S. Mansour   +2 more
doaj   +1 more source

Progress in Strain Engineering of 2D‐Integrated Heterostructures for Ultrasensitive Sensors

Advanced Science, Volume 13, Issue 33, 15 June 2026.
 . ABSTRACT Two‐dimensional (2D) integrated heterostructures have emerged as a cornerstone in the advancement of next‐generation sensor technologies. These heterostructures, which combine materials with different dimensionalities, have led to significant breakthroughs in sensing performance and device integration.
That Buu Ton, Tuan Sang Tran, Duc Khanh Tran, Van Thanh Dau, Dzung Viet Dao   +4 more
wiley   +1 more source

Rejuvenated Amorphous Alloys: Processing Methods, Microstructures and Mechanical Properties

Advanced Science, Volume 13, Issue 33, 15 June 2026.
Three rejuvenation methods – mechanical and thermal rejuvenation, and other rejuvenation routes such as ultrasonic processing – can be used to modify structures of glassy alloys, especially atomic clusters, and therefore enhances plasticity and activates work‐hardening behaviors.
Can Yang, Yu Chen, Chunguang Tang, Si Lan, Jun Tan, Heng Ye, Hua Chen, Zhifu Yao, Jürgen Eckert, Dongxian Zhang, Jian‐Zhong Jiang   +10 more
wiley   +1 more source

Discontinuous PWM Method for Single Inverter Dual Parallel PMSM Drives to Minimize Power Loss of Inverter

IEEE Access
This paper proposes a discontinuous pulse width modulation (DPWM) method for single inverter dual parallel (SIDP) permanent magnet synchronous motor (PMSM) drives to minimize the power loss of the inverter.
Sang-Jun Lee, Kyo-Beum Lee
doaj   +1 more source

Discontinuous Multilevel Pulse Width Modulation Technique for Grid Voltage Quality Improvement and Inverter Loss Reduction in Photovoltaic Systems

Electronics
In the last decade, countries have experienced increased solar radiation, leading to an increase in the use of solar photovoltaic (PV) systems to boost renewable energy generation. However, the high solar penetration into these systems can disrupt the normal operation of the distribution grid. Thus, a major concern is the impact of these units on power
Juan-Ramon Heredia-Larrubia, Francisco M. Perez-Hidalgo, Antonio Ruiz-Gonzalez, Mario Jesus Meco-Gutierrez   +3 more
openaire   +2 more sources

Temperature‐Graded Deposition of HfZrOx for Ferroelectric Capacitors With Enhanced Polarization, Reliability, and Switching

Advanced Electronic Materials, Volume 12, Issue 12, 22 June 2026.
Temperature‐graded ALD of HfZrOx (HZO) enables strain‐enhanced stabilization of the ferroelectric o‐phase, achieving simultaneously high polarization, fast switching, and robust endurance in BEOL‐compatible FeCAPs. ABSTRACT Ferroelectric Hf0.5Zr0.5O2 (HZO) capacitors hold great promise for next‐generation nonvolatile memory and logic applications ...
Sheng‐Yen Zheng, Yin‐Chen Sun, Yu‐Cheng Kao, Hsin‐Yu Hsu, Pin‐Jiun Wu, Yung‐Hsien Wu   +5 more
wiley   +1 more source