Results 71 to 80 of about 36,077 (260)
Advanced Robotics Research, EarlyView.Permanent magnet putty (PMP) integrates high‐coercivity NdFeB particles with a dynamic polyborosiloxane–Ecoflex matrix, achieving rapid self‐healing (90% mechanical recovery in 10 s) and magnetic recovery within 20 min. With twice the sensitivity of commercial putties, PMP enables precise 5–30 N force detection and discrimination between pressing and ...
Ruotong Zhao +5 more
wiley +1 more source
Potentialities of the sol-gel route to develop cathode and electrolyte thick layers Application to SOFC systems [PDF]
, 2008 In this work, we report the potential of sol–gel process to prepare cathode and electrolyte thin and thick layers on anodic NiO-YSZ supports which were also made from powders prepared by sol–gel route.
Ansart, Florence +5 more
core +4 more sources
Advanced Sensor Research, EarlyView.This Review focuses on assessing and providing perspective on the field of rationally‐designed optical sensors constructed with single‐walled carbon nanotubes. The literature is reviewed and evaluated for SWCNT‐based sensors constructed with biomolecular recognition elements, including proteins, peptides, and oligonucleotides, as well as their methods ...
Amelia K. Ryan +4 more
wiley +1 more source
Wear effects and mechanisms of soot-contaminated automotive lubricants [PDF]
, 2006 A study has been carried out to investigate the influence of soot-contaminated automotive lubricants in the wear process of a simulated engine valve train contact. Previous research on this topic has been mainly performed from a chemical point of view in
Dwyer-Joyce, R.S. +2 more
core +1 more source
A Covalent 3D CNT@rGO Nano‐Hybrid for High‐Efficiency Conductivity in Lithium‐Ion Batteries
Advanced Science, EarlyView.A facile one‐step CVD strategy achieves high‐yield (7692.31%) growth of CNTs on rGO, forming a covalently bonded 3D CNT@rGO hybrid. This structure enables multidirectional conductive networks in LiFePO4 cathodes, delivering superior rate performance, high ICE (99.88%), and 96.32% capacity retention after 300 cycles at 1 C.
Junwen Tang +10 more
wiley +1 more source
Rheological Behavior of an Algerian Natural Kaolin: Effect of Dispersant
CeramicsThis work presents the study of the rheology ical behavior of Algerian kaolin (DD1) suspensions considering two types of electro-steric dispersants (Hypermer KD1 and Darvan 7) and the evaluation of their effectiveness at neutral pH.
Fouzia Chargui +3 more
doaj +1 more source
The Effects of Low Temperature Cooking on the Deinking of Groundwood [PDF]
, 1983 An experiment was designed to lower the temperature of the cooking stage in the deinking of groundwood. The cook chemicals consisted of sodium meta-silicate, sodium carbonate, hydrogen peroxide and surfactants.
De Vries, George
core +1 more source
Advanced Science, EarlyView.This study employs a nanochain engineering approach combined with an in situ oxidation strategy to fabricate self‐insulating iron‐based magnetic nanochains, addressing the challenge of balancing magnetic coupling and electrical insulation in soft magnetic materials.
Dingrong Zuo +8 more
wiley +1 more source
Effect of beating process to soda anthraquinone pulp of oil palm male flower spikes fibre [PDF]
, 2015 This study was carried out to investigate the effect of beating process to the characteristics of pulp and paper produced from oil palm oil male flower spikes (OPMFS). OPMFS pulp was prepared according to chemical Soda-AQ pulping process.
Adnan, S. +6 more
core +1 more source
A Novel Metal Foam‐Supported Solid Oxide Fuel Cell With High Specific Power
Advanced Science, EarlyView.Solid oxide fuel cells (SOFCs) employing metal foam supports with an ultrahigh porosity of 90% and average pore size of 100 µm are successfully fabricated. The metal foam architecture significantly enhances gas diffusion coefficients, effectively reducing concentration polarization while simultaneously decreasing areal mass.
Jingbo Ma +4 more
wiley +1 more source