Results 201 to 210 of about 608,190 (291)

Model analysis of heat dissipation and heat transfer

Journal of Environmental Science, Computer Science and Engineering & Technology, 2020
openaire   +1 more source

Controlled Synthesis of Tri‐ and Multi‐Doped Graphene

Advanced Materials Interfaces, EarlyView.
This review systematically evaluates synthesis routes for tri‐ and multi‐doped graphene, from hydrothermal and pyrolysis methods to flash Joule heating, critically assessing how each governs dopant incorporation, bonding configuration, and resulting electronic properties.
Maria Hasan, Alicja Bachmatiuk, Gražyna Simha Martynková, Karla Čech Barabaszová, Mark Hermann Rümmeli   +4 more
wiley   +1 more source

On-chip solitons are gaining new colors. [PDF]

Light Sci Appl
Moille G, Srinivasan K, Chembo YK.
europepmc   +1 more source

Thermal Enhancement of TADF‐OLED Performance: Size of Active Area Matters

Advanced Materials Interfaces, EarlyView.
Large‐area TADF‐based OLEDs can be used as thermally assisted light‐emitting devices, in which moderate waste heat can partially compensate for efficiency losses associated with increasing active area. ABSTRACT Temperature significantly impacts the performance of light‐emitting diodes, typically causing degradation as they heat up. However, OLEDs using
Demyd V. Pekur, Denis M. Khmil, Petro S. Smertenko, Alexander N. Fedoryak, Chih‐Hung Ko, Chih‐Hao Chang, Dovydas Blazevicius, Gintare Krucaite, Saulius Grigalevicius, Oleg P. Dimitriev   +9 more
wiley   +1 more source

Chaotic and quantum dynamics in driven-dissipative bosonic chains. [PDF]

Commun Phys
Ferrari F, Minganti F, Aron C, Savona V.
europepmc   +1 more source

Adsorbent Materials for Hydrocarbons Removal by Geopolymerization of Halloysite Clay Nanotubes Filled Within Chitosan Matrix

Advanced Materials Interfaces, EarlyView.
Alkaline activation of halloysite clay nanotubes embedded in a chitosan matrix converts bionanocomposite films into porous geopolymeric materials with enhanced adsorption capacity toward hydrocarbons in both vapor and aqueous phases. The improved adsorption performance was demonstrated by the efficient capture of dodecane vapors and phenol from water ...
Alessandro Lo Bianco, Marta Giuseppina Ebbreo, Giuseppe Cavallaro, Martina Maria Calvino, Yafei Zhao, Simonpietro Agnello, Giuseppe Lazzara   +6 more
wiley   +1 more source

Kondo-Zeno crossover in the dynamics of a monitored quantum dot. [PDF]

Nat Commun
Vanhoecke M, Schirò M.
europepmc   +1 more source

Atomistic Insights into Gradient Architecture Driven Strengthening in Additively Manufactured Cu–Ni Stepwise Graded Structures

Advanced Materials Interfaces, EarlyView.
Atomistic simulations reveal the interlayer mechanics of additively manufactured materials, showing how build direction and layer interfaces govern diffusion, defect evolution, and mechanical strength. Distinct anisotropic behavior arises from interface‐controlled deformation and dislocation activity, establishing critical links between microstructural
Rohit Singh, Jinoop Arackal Narayanan
wiley   +1 more source

Anthracene-functionalized dipolar glass copolymers as precursors for high-dielectric single-chain nanoparticles. [PDF]

Chem Sci
Bonardd S, Maiz J, Maisueche J, Verde-Sesto E, Pomposo JA.   +4 more
europepmc   +1 more source

Additively Manufactured Porous Ceramics as Tunable Dielectrics for Passive Temperature Sensing

Advanced Materials Technologies, EarlyView.
Porous ceramic lattices, 3D‐printed from a multicomponent oxide ink, are integrated with LC resonators for passive wireless temperature sensing. By tuning porosity, the dielectric properties and RF response are engineered to produce distinct resonant frequency shifts with temperature. The results establish a structure‐driven approach to customizing the
Sogol Heidarishahrivar, Aminul Islam, Chang Woo Gal, Insup Kim, Yeong‐Jin Choi, Woo Soo Kim   +5 more
wiley   +1 more source