Results 51 to 60 of about 573,373 (334)

Studi Power Wheeling Dikawasan Industri Jababeka [PDF]

open access: yes, 2017
Electricity Jababeka industrialarea is provided by PT Bekasi Power through 150 kV PLN's own transmission with Power Wheeling concept that is the joint utilization of transmission system which has a few definitions, for example, the utilization of ...
Jurnal, R. T. (Redaksi)
core  

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

open access: yesAdvanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti   +11 more
wiley   +1 more source

Preface

open access: yesProceedings of: Tagung Zukünftige Stromnetze - Future Power Grids Conference
Our event reliably addresses the key challenges in power grids and serves as a comprehensive platform for personal exchange at a professional level among all relevant stakeholders every year. The rapid pace of developments and necessary adjustments in
Anke Hüneburg, Oliver Franz
doaj   +1 more source

The efficiency of electric power supply with the transmission of peak loads to distributed generation

open access: yesIOP Conference Series: Earth and Environmental Science, 2021
Abstract A model of a radial power supply system in MatLAB was compiled to perform the research. The transformer substation is represented by a step-down transformer, the load of the substations in the form of a resistance. Electricity is transmitted to the substations along three power transmission lines. The power center is represented
T Yu Brostilova   +3 more
openaire   +1 more source

Characterization of Nitinol Produced by Laser Powder Bed Fusion for Mechanical Metamaterial Applications

open access: yesAdvanced Engineering Materials, EarlyView.
Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek   +5 more
wiley   +1 more source

Development of a Cross-Voltage-Level Planning Approach for Automated Strategic Network Planning

open access: yesProceedings of: Tagung Zukünftige Stromnetze - Future Power Grids Conference
This contribution presents a method for automated strategic network planning for electric distribution networks across voltage levels. Three approaches for cross-voltage-level planning using level-separate network-datasets are presented.
Christoph Becker   +4 more
doaj   +1 more source

Influence of an Argon/Silane Atmosphere on the Temperature of a Thermal Plasma

open access: yesAdvanced Engineering Materials, EarlyView.
The influence of a silane‐doped argon atmosphere on the chemical composition and temperature of a thermal nontransferring argon plasma is investigated using optical emission spectroscopy. As a result of the high amount of free electrons resulting from the stepwise ionization and dissociation of the silane molecule, even a silane addition of 0.01 vol ...
Lena Kreie   +4 more
wiley   +1 more source

Mastering Participatory Living Labs

open access: yesProceedings of: Tagung Zukünftige Stromnetze - Future Power Grids Conference
This paper presents the concept and implementation of participatory living labs in the context of the unIT-e² project, which aims to integrate electromobility into the energy system efficiently.
Jeremias Hawran, Daniela Wohlschlager
doaj   +1 more source

Thermomechanical Fatigue and Creep–Fatigue Interaction of Inconel 718 Additively Manufactured by Laser Beam Powder Bed Fusion

open access: yesAdvanced Engineering Materials, EarlyView.
Thermomechanical fatigue tests of laser beam powder bed fusion (PBF‐LB) Inconel 718 show that the additively manufactured material reaches almost the lifetimes of conventionally‐rolled material under no‐dwell conditions. Introducing dwell times at the maximum temperature markedly reduces the lifetimes due to pronounced grain boundary sliding associated
Stefan Guth   +6 more
wiley   +1 more source

Grid Fees in Transition

open access: yesProceedings of: Tagung Zukünftige Stromnetze - Future Power Grids Conference
The reform of §14a of the German Energy Industry Act (EnWG) opens up the possibility for customers to choose variable grid fees for the first time.
Niklas Jooß   +2 more
doaj   +1 more source

Home - About - Disclaimer - Privacy