Results 81 to 90 of about 88,220 (306)
Data in Brief, 2015 Dynamic building energy simulations need hourly weather data as input. The same high temporal resolution is required for assessments of future heating and cooling energy demand.
Kirsti Jylhä +7 more
doaj +1 more source
Just Warmth: Developing Equitable and Sustainable District Heating Systems in Scotland [PDF]
, 2018 Common Weal is of the view that:- The aims of the European Union’s Energy Performance of Buildings Directive (EPBD), which requires EPCs to be produced for all new buildings and those being sold or rented out, are fundamentally sound and should serve to ...
Baker, Keith, Mould, Ron
core +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Potentials of the new design concepts of district heating and cooling toward integration with renewable energy sources [PDF]
, 2013 This paper discusses the opportunities of the new design concepts of district heating and cooling towards the integration of renewable energy sources. A comparison between the medium-temperature district heating and the last generation of low-temperature
Himpe, Eline +2 more
core +1 more source
Advanced Engineering Materials, EarlyView.Creep experiments at 900°C on coarse‐grained steel‐ceramic composites containing recycled magnesia reveal that higher ceramic volume fractions significantly enhance the creep resistance. Detailed EBSD investigations identify subgrain formation in the steel matrix as the dominant deformation mechanism.
Moritz Müller +6 more
wiley +1 more source
Technical and Economic Reconstruction Proposal for Gas Boiler Plant to Satisfy Efficient District Heating System Requirements [PDF]
MATEC Web of ConferencesThe paper presents the efficiency criteria for heat and cooling supply for a so-called efficient district heating and cooling system as defined in Directive 2023/1791 on energy efficiency and amending Regulation (EU) 2023/955.
Világi František +6 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.High‐frequency (HF) welding of steel is limited by oxide inclusions that degrade weld quality. This study demonstrates, for the first time, the integration of a nonthermal Ar/H2 dielectric barrier discharge (DBD) plasma jet into HF welding. Local plasma treatment provides effective shielding and in‐situ oxide reduction, resulting in markedly fewer and ...
Viktor Udachin +4 more
wiley +1 more source
Possibility of Heat Pump Use in Hot Water Supply Systems
Journal of Sustainable Development of Energy, Water and Environment Systems, 2016 The problem of modernization of the heat module (HM) with two-stage mixing scheme connection of hot water supply (HWS) by installations of the heat pump (HP) during interheating period is considered.
Tatyana Babak +4 more
doaj +1 more source
Handbook of Establishing and Maintaining Oxygen‐Free Atmospheres
Advanced Engineering Materials, EarlyView.This study presents a practical framework for creating oxygen‐free atmospheres at ambient pressure using silane‐doped inert gases. The results show that ultra‐low oxygen levels and strongly reduced water content can be achieved through controlled silane dosing, drying systems, and sensor monitoring.
Sascha Jan Zimmermann +3 more
wiley +1 more source
Oxide‐Free Titanium Coatings by Wire Arc Spraying in a Silane‐Doped Inert Atmosphere
Advanced Engineering Materials, EarlyView.A silane‐doped argon atmosphere enables the production of oxide‐free titanium coatings via twin‐wire arc spraying at ambient pressure. This innovative approach eliminates residual oxygen, creating process conditions that prevent oxidation and nitride formation.
Manuel Rodriguez Diaz +4 more
wiley +1 more source