Results 131 to 140 of about 2,633,621 (286)

Private capital formation: Short- and long-run crowding-in (out) effects in ASEAN, 1971-99 [PDF]

open access: yes
This study presents an empirical assessment of the factors that have stimulated (deterred) private investment in the Association of Southeast Asian Nations (ASEAN) economies during the past three decades. The results for the short-run suggest that output
Anthony Bende-Nabende, Jim Slater
core  

Tetraquarks in AdS/QCD

open access: yes, 2012
Multiquark correlations inside hadrons can have a significant and in some cases even striking impact on the hadron spectrum. We show how such correlations in general, and mesons with a dominant tetraquark content in particular, emerge holographically in ...
Forkel, Hilmar
core   +1 more source

Development of Sustainable MgO–C Refractories Using MgO–C Recyclates and a Novel Eco‐Friendly Fructose–Tannin Binder Crosslinked With Citric Acid

open access: yesAdvanced Engineering Materials, EarlyView.
This study develops sustainable MgO–C refractories using recycled materials and eco‐friendly fructose–tannin binders. The enhanced performance of citric acid as a cross‐linker and functional additives on mechanical and thermomechanical properties was examined. Characterization included strength tests, immersion trials, and microstructural and inclusion
Dinesh K. Gunasekar   +7 more
wiley   +1 more source

Multifunctional Crushing and Piezoresistive Self‐Sensing in Conductive Epoxy/CNT‐Coated Polyetherimide TPMS Lattices

open access: yesAdvanced Engineering Materials, EarlyView.
This study reports lightweight polyetherimide triply periodic minimal surfaces lattices coated with carbon nanotube‐reinforced epoxy that combine mechanical robustness with self‐sensing. The conformal coating enhances stiffness, strength and energy absorption while enabling reliable strain monitoring.
A. Triay   +3 more
wiley   +1 more source

Solid‐State Diffusion and Intermetallic Phase Formation in Roll‐Bonded Mg–Zn Composites With Kirigami‐Patterned Inlay

open access: yesAdvanced Engineering Materials, EarlyView.
Mg–Zn composites with a thickness of 0.21 mm were fabricated using roll bonding of a kirigami‐patterned Mg alloy inlay within a Zn matrix. Thermal activation following this process led to the formation of tailored intermetallic structures, which provided the composite with enhanced flexural strength.
Yaroslav Frolov   +4 more
wiley   +1 more source

Investigating the effect of the Dominant Hand on Grip Strength and Hand Dexterity [PDF]

open access: yesبهداشت و ایمنی کار
Introduction: In all societies, tools and equipment are generally designed for right-handed people, who make up approximately 90% of the population, but left-handed and ambidextrous people (those who use both hands in manual activities) also live among ...
Mohammad Sadegh Sohrabi   +3 more
doaj  

Meat Grinder Injury to the Hand: Serial Cases [PDF]

open access: yes, 2012
Introduction.Although meat grinder injury to the hand is not a common case, it causes a wide spectrum of injuries that result not only in tremendous physical and emotional pain but also substantial economic impact as well.Case presentation.Three ...
Lubis, N. R. (Nur)
core  

Rafting of Ni‐Based Superalloys Under Multiaxial Load as Understood by Phase‐Field Simulations and Critical Experiments

open access: yesAdvanced Engineering Materials, EarlyView.
Phase‐field simulations coupled with dislocation‐density‐based crystal plasticity modeling reproduce γ′ rafting behavior in single‐crystal Ni‐based superalloys under varied loading conditions. The model captures both macroscopic creep and microscopic morphology evolution, with results matching high‐temperature creep experiments.
Micheal Younan   +5 more
wiley   +1 more source

Home - About - Disclaimer - Privacy