Results 91 to 100 of about 319 (133)

Defects in Metal Additive Manufacturing: Formation, Process Parameters, Postprocessing, Challenges, Economic Aspects, and Future Research Directions. [PDF]

3D Print Addit Manuf
Haribaskar R, Kumar TS.
europepmc   +1 more source

Strain-Based Assessment to Evaluate Damage Caused by Deep Rolling. [PDF]

Materials (Basel)
Pertoll T, Leitner M, Buzzi C, Boronkai L.   +3 more
europepmc   +1 more source

The Impact of Pre- and Post-Treatment Processes on Corrosion Resistance of Micro-Arc Oxidation Coatings on Mg Alloys: A Systematic Review. [PDF]

Materials (Basel)
Chi J, Zhang H, Song S, Zhang W, He X, Nong Z, Cui X, Liu T, Man T.   +8 more
europepmc   +1 more source

Fatigue Life Analysis of Titanium Torsion Spring Based on Continuous Damage Mechanics. [PDF]

Materials (Basel)
Meng D, Zhang C, Yang F, Duan F.
europepmc   +1 more source

Effect of Temperature on the Sliding Wear Behaviors of Carburized BG801 Bearing Steel. [PDF]

Materials (Basel)
Wang Q, Meng Z, Qi S, Luo C, Guo X, Wang Z, Song K.   +6 more
europepmc   +1 more source

The Effect of Post Heat Treatment on the Microstructure and Mechanical Properties of Cold-Sprayed Zn-6Cu Deposits. [PDF]

Materials (Basel)
Hu XZ, Tan XB, Xie B, Yao HL, Yang C, Zhou T.   +5 more
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Mechanical behavior study of asymmetric deformation in double-sided symmetrical sequential shot peening process

International Journal of Advanced Manufacturing Technology, 2021
Shot peening is widely used in the aeronautical industry to enhance the fatigue life of the parts and form large, thin, and complex components, such as wing and fuselage skins. Previous research on peen forming simulation has rarely considered the influence of the shot peening sequence on the resulting deformed shape.
Chengyu Wang, Weigang Li, Jianjun Jiang, Xin Chao, Weikui Zeng, Jie Yang   +5 more
exaly   +2 more sources

Technical note A study on stress, reflection and double shot peening to inrease compressive residual stress

Fatigue and Fracture of Engineering Materials and Structures, 2000
The technique of shot peening is commonly used to increase the fatigue limit of a steel. However, there are many practical difficulties in applying it to very high HV steel and complicated components. To overcome these problems, the authors proposed two new methods: stress double shot peening and stress reflection double shot peening.
H. Ishigami, K. Matsui, Y. Jin, K. Ando
exaly   +2 more sources

Study on Double Shot Peening and Fatigue Limit of Gear

Key Engineering Materials, 2000
Ando Kotoji
exaly   +2 more sources

Improvement of traction-traction fatigue properties of A100 steel plate-hole-structure by double shot peening

International Journal of Fatigue, 2022
Weidong Zhao, Junnan Wu, Daoxin Liu
exaly   +2 more sources