Results 11 to 20 of about 1,345,286 (303)
Aspects of energy requirements for rock drilling [PDF]
, 1974 Development of laboratory rock breakage techniques to relate energy and surface area produced by slow compression, drop hammer and stamp mill. A detailed study of laboratory rotary-percussive drilling in a wide range of rocks under different ...
Wootton, David
core +7 more sources
Improving gas bubbles’ half life in foam drilling fluid [PDF]
, 2013 An underbalanced drilling using foam drilling fluid is one of the most effective solutions which are capable of preventing formation damage, differential sticking, or circulation lost.
Ismail, Ahmad Shamsulizwan +6 more
core +1 more source
Experimental study on ultra-low temperature drilling fluid in Arctic permafrost
, 2021 Drilling fluid in Arctic permafrost needs to have good ultra-low temperature rheology, shale inhibition, hydrate inhibition and environmental protection performance.
Zhang, Yubin +11 more
core +1 more source
Induced drilling strains in glass fibre reinforced epoxy composites [PDF]
, 2013 Residual strains induced by drilling of glass-fibre reinforced polymers (GFRP) were determined using a hybrid experimental-numerical methodology. Experimentally, a set of GFRP specimens were drilled under well-defined tensile (calibration) stresses ...
STIFFEL, J.-H. +16 more
core +1 more source
Tool wear monitoring and hole surface quality during CFRP drilling [PDF]
, 2014 The present investigation focuses on the evaluation of tool wear and surface integrity in the context of CFRP cutting. Series of drilling experiments were performed on CFRP plates using cemented carbide solid drills with the aim to investigate ...
RAMIREZ, Christophe +3 more
core +1 more source
Evaluation of the performance of coated and uncoated carbide tools in drilling thick CFRP/aluminium alloy stacks [PDF]
, 2013 This paper aims to establish the wear mechanisms of coated and uncoated tungsten carbide drills when drilling carbon fibre reinforced plastics (CFRP)/aluminium alloy (Al) stacks. During the drilling experiments, thrust forces were measured.
MONTOYA, Maxime +3 more
core +1 more source
Measurement of laser absorptivity for operating parameters characteristic of laser drilling regime [PDF]
, 2008 Publisher version : http://iopscience.iop.org/0022-3727/41/15/155502/Laser drilling in the percussion regime is commonly used in the aircraft industry to drill sub-millimetre holes in metallic targets.
SCHNEIDER, Matthieu +3 more
core +1 more source
Hawaii Scientific Drilling Project 1993 [PDF]
, 1994 Content: Project Summary, History of Hawaii Project, Permit History, Continental Scientific Drilling Office's Role, Setup and Coring of Kahi Puka Site, Downhole Problems, Cures for Problems, Conclusions, Appendices: Correspondence for Increase in Depth ...
core +3 more sources
International Journal of Electrochemical Science, 2020 Today, reclamation and reuse of wastewater from textile, food and pharmaceutical industries are the big challenges for researchers to decrease the diseases and pollution in the world.
Dichen Tan +6 more
doaj +1 more source
Drilling performance analysis of impregnated micro bit [PDF]
Mechanical Sciences, 2022 The cutting mechanical properties of impregnated diamond bit depend on the performance of its cutting elements. Aiming at the factors affecting the cutting element performance of impregnated diamond bit, the laboratory rock breaking experiment of ...
D. Song +11 more
doaj +1 more source