Results 61 to 70 of about 218,829 (293)

Wearable Smart Textiles for Long-Term Electrocardiography Monitoring—A Review

open access: yesSensors, 2021
The continuous and long-term measurement and monitoring of physiological signals such as electrocardiography (ECG) are very important for the early detection and treatment of heart disorders at an early stage prior to a serious condition occurring.
Abreha Bayrau Nigusse   +4 more
doaj   +1 more source

An investigation of planar array system artefacts generated within an electrical impedance mammography system developed for breast cancer detection [PDF]

open access: yes, 2014
An Electrical Impedance Mammography (EIM) planar array imaging system is being developed at the University of Sussex for the detection of breast cancers.
Bilal, Rabia   +3 more
core  

Tribocorrosion Properties of PEO Coatings Produced on AZ91 Magnesium Alloy with Silicate- or Phosphate-Based Electrolytes [PDF]

open access: yes, 2018
In this work, the tribocorrosion behavior of plasma electrolytic oxidation (PEO)-coated AZ91 samples was studied. In particular, two different coatings were produced and compared. One was obtained with an alkaline electrolyte containing sodium phosphate,
Brunelli, Katya   +7 more
core   +2 more sources

Surface electromyography using dry polymeric electrodes

open access: yesAPL Bioengineering, 2023
Conventional wet Ag/AgCl electrodes are widely used in electrocardiography, electromyography (EMG), and electroencephalography (EEG) and are considered the gold standard for biopotential measurements. However, these electrodes require substantial skin preparation, are single use, and cannot be used for continuous monitoring (>24 h).
Nicolas Steenbergen   +12 more
openaire   +4 more sources

Novel Tailoring of Ternary ZnS‐MXene‐TiO2 Nanocomposite Heterojunction and Its Tunable Electrochemical Properties With Enhanced Photocatalytic Degradation

open access: yesAdvanced Engineering Materials, EarlyView.
ZnS‐MXene‐TiO2 nanocomposite heterojunction for photocatalytic decomposition of this methylene blue dye (MB) greatly improves light absorption, charge separation, and active site area. Two‐dimensional MXene forms nanocomposites by easily combining them with 0D (quantum dots), 1D (tube and wire), 2D (plane and sheet), and 3D (particle and lamellar ...
Latiful Kabir   +7 more
wiley   +1 more source

Corrosion and Process Analysis of a Preoxidized MgO Recyclate‐Based Cermet Anode in Laboratory‐Scale Na‐Cryolite Molten Salt Electrolysis of Aluminum at 1000°C

open access: yesAdvanced Engineering Materials, EarlyView.
EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk   +7 more
wiley   +1 more source

Enhancement of single-lead dry-electrode ECG through wavelet denoising

open access: yesFrontiers in Signal Processing
Neonatal electrocardiogram (ECG) monitoring is an important diagnostic tool for identifying cardiac issues in infants at birth. Long-term remote neonatal dry-electrode ECG monitoring solutions can be an additional step for preventive healthcare measures.
Abdelrahman Abdou, Sridhar Krishnan
doaj   +1 more source

3D Printable Dry EEG Electrodes with Coiled-Spring Prongs

open access: yesSensors, 2020
Various dry electroencephalography (EEG) electrodes have been developed. Dry EEG electrodes need to be pressed onto the scalp; therefore, there is a tradeoff between keeping the contact impedance low and maintaining comfort.
Masaya Kimura   +4 more
doaj   +1 more source

Single-particle levitation system for automated study of homogeneous solute nucleation [PDF]

open access: yes, 2006
We present an instrument that addresses two critical requirements for quantitative measurements of the homogeneous crystal nucleation rate in supersaturated aqueous solution. First, the need to perform repeated measurements of nucleation incubation times
Flagan, Richard C.   +2 more
core   +1 more source

Interaction of MgO Recyclate‐Based Cermet Anode With KF‐AlF3‐Al2O3 at 800°C During Laboratory Scale Aluminum Molten Salt Electrolysis

open access: yesAdvanced Engineering Materials, EarlyView.
A carbon‐free, as‐sintered MgO–steel cermet anode, fabricated via cold isostatic pressing using MgO–C refractory recyclate, was evaluated under laboratory‐scale K‐cryolite electrolysis at 800°C. Operation at this reduced temperature, combined with the electrolyte's limited electrical conductivity, led to an increase in cell voltage.
Farhan Hossain   +7 more
wiley   +1 more source

Home - About - Disclaimer - Privacy