Toward a better understanding of tool wear effect through a comparison between experiments and SPH numerical modelling of machining hard materials [PDF]
, 2009 The aim of this study is to improve the general understanding of tungsten carbide (WC–Co) tool wear under dry machining of the hard-to-cut titanium alloy Ti6Al4V. The chosen approach includes experimental and numerical tests.
Bil +26 more
core +7 more sources
An experimental study of the effect of high-pressure water jet assisted turning (HPWJAT) on the surface integrity [PDF]
, 2011 This study deals with the effect of High-Pressure Water Jet Assisted Turning (HPWJAT) of austenitic stainless steels on chip shape and residual stresses. The machining of the austenitic stainless steels represents several difficulties. Recently, research
HABAK, Malek, LEBRUN, Jean-Lou
core +4 more sources
Metals, 2023 Machining of AISI 304 austenitic stainless steel is considered to be difficult due to its structural aspects and low thermal conductivity, which leads to increased temperatures during machining.
Rüstem Binali +3 more
doaj +1 more source
Residual Stresses in Machining of AISI 52100 Steel under Dry and Cryogenic Conditions: A Brief Summary [PDF]
, 2014 17th Conference on Material Forming (ESAFORM) - FinlandResidual stress is one of the most important surface integrity parameter that can significantly affect the service performance of a mechanical component, such as: contact fatigue, corrosion ...
BATISTA, Antonio +3 more
core +4 more sources
Assessment of Machinability of Ti6Al4V Alloy Under Dry Conditions [PDF]
MATEC Web of ConferencesTitanium alloys pose significant challenges during machining, necessitates a thorough investigation into the impact of process parameters on machining Ti6Al4V alloy.
Younas Muhammad +3 more
doaj +1 more source
SURFACE FINISH WHEN THREADING TITANIUM-BASED ALLOY UNDER DRY MACHINING [PDF]
Journal of Mechanical Engineering and Sciences, 2014 This paper discusses the quality of surface finish when threading titanium-based alloy under dry condition. The quality of surface finish was studied at various cutting parameters and at the two extreme stages of the machining process, i.e.
Siti Hartini Hamdan +2 more
doaj +1 more source
International Journal of Technology, 2022 In this paper, the application of dry machining as part of contributions for development of a sustainable environment in the machining industry is explained.
Shamsuddin Sulaiman +4 more
doaj +1 more source
The effect of an organic pentasulfide EP additive in turning and milling operations [PDF]
, 2014 Coopération avec Ecole Centrale LyonBecause a cutting fluid could be equally used for different cutting operations, this study proposed to investigate the behavior of a well-known extreme-pressure additive (pentasulfide) in both turning and milling ...
BIERLA, Aleksandra +4 more
core +4 more sources
Cryogenic turning of in-house cast magnesium based MMCs: A comprehensive investigation
Journal of Materials Research and Technology, 2020 To increase fuel efficiency, the demand for materials having high specific strength is increasing in automotive and aerospace industry. In this context, a tailor-made AXZ911/10SiC Metal Matrix Composites (MMCs) is developed.
Navneet Khanna +4 more
doaj +1 more source
Wear and surface characteristics on tool performance with CVD coating of Al2O3/TiCN inserts during machining of Inconel 718 alloys [PDF]
Archive of Mechanical Engineering, 2021 The Inconel 718 alloys, which are primarily temperature resistant, are widely used in aviation, aerospace and nuclear industries. The study on dry cutting processes for this alloy becomes difficult due to its high hardness and low thermal conductivity ...
Shailesh Rao Agari
doaj +1 more source