Study of the Tool Wear Process in the Dry Turning of Al–Cu Alloy
Metals, 2019 Light alloy machining is a widely implemented process that is usually used in the presence of cutting fluids to reduce wear and increase tool life. The use of coolants during machining presents negative environmental impacts, which has increased interest
Moises Batista +4 more
doaj +1 more source
Experimental Investigation on Ultrasonic Atomization Assisted Turning of Titanium Alloy
Micromachines, 2020 There are high cutting temperatures, large tool wear, and poor tool life in conventional machining, owing to the superior strength and low thermal conductivity of titanium alloy. In this work, ultrasonic atomization assisted turning (UAAT) of Ti6Al4V was
Jianbing Meng +6 more
doaj +1 more source
Modeling and Optimal Design of Machining-Induced Residual Stresses in Aluminium Alloys Using a Fast Hierarchical Multiobjective Optimization Algorithm [PDF]
, 2011 The residual stresses induced during shaping and machining play an important role in determining the integrity and durability of metal components. An important issue of producing safety critical components is to find the machining parameters that create ...
Christophe Pinna +10 more
core +1 more source
On the Machinability of an Al-63%SiC Metal Matrix Composite [PDF]
, 2020 This paper presents a preliminary study of aluminium matrix composite materials during machining, with a special focus on their behavior under conventional processes.
Batista Ponce, Moisés +4 more
core +1 more source
Influence of cutting parameters and tool wear on the surface integrity of cobalt-based Stellite 6 alloy when machined under a dry cutting environment [PDF]
, 2016 The efficiency of a machining process can be measured by evaluating the quality of the machined surface and the tool wear rate. The research reported herein is mainly focused on the effect of cutting parameters and tool wear on the machined surface ...
Alexander Galloway +19 more
core +1 more source
State of art of cooling method for dry machining
MATEC Web of Conferences, 2017 The usage of cutting fluid in the machining operations will not only poses health risk to the workers but also creates environmental challenges associated with fluid treatment and disposal.
Ramachandran Kaaliarasan +5 more
doaj +1 more source
Use of Multi-Objective Optimization Technique (Taguchi-GRA Approach) in Dry Hard Turning of Inconel 625 [PDF]
INCAS Bulletin, 2020 Current developments in manufacturing industries consider developing a suitable optimization technique for achieving improved machining performance. This study investigates the optimum values of machining parameters required namely –cutting speed (v ...
Chinmaya PADHY, Pariniti SINGH
doaj +1 more source
Indirect Adhesion Wear Parametric Analysis in the Dry Turning of UNS A97075 Alloys [PDF]
, 2017 In this work a study of the influence of cutting parameters (cutting speed, feed and depth of cut) on indirect adhesion tool wear in the dry machining of UNS A97075 Al-Zn alloys has been made. In addition, an experimental methodology for a first approach
Marcos Bárcena, Mariano +3 more
core +2 more sources
Engineering ProceedingsAluminum, one of the most abundant metals found on our planet, plays a crucial role in manufacturing as it is lightweight and resistant to corrosion and has excellent machinability.
Mahendra U. Gaikwad +5 more
doaj +1 more source
Indirect monitoring method of tool wear using the analysis of cutting force during dry machining of Ti alloys [PDF]
, 2017 In recent decades, optimize tool life is in constant evolution so many researchers have focused to analysis the tool wear by indirect monitoring (e.g. acoustic emission, cutting forces, vibrations) that plays a significant role in control and improvement
Marcos, Mariano +3 more
core +2 more sources