Results 181 to 190 of about 1,660 (216)

Load Compensation using DSTATCOM

2002
In this chapter we shall discuss shunt compensation of distribution systems. The primary aims of a shunt compensator in a distribution system are to cancel or suppress the effect of poor load power factor such that the current drawn from the source has a near unity power factor.
Arindam Ghosh, Gerard Ledwich
openaire   +1 more source

Load compensation with DSTATCOM and BESS

2012 IEEE 5th India International Conference on Power Electronics (IICPE), 2012
This paper deals with modeling & control of Distribution Static Compensator (DSTATCOM) and Battery Energy Storage System (BESS) using Simulink and SimPower System in MATLAB environment. The results are presented for a test system with/without DSTATCOM for a wide variety of system disturbances.
Alka Singh, Suman Bhowmick, Kapil Shukla
openaire   +1 more source

The application of a DSTATCOM to an industrial facility

2002 IEEE Power Engineering Society Winter Meeting. Conference Proceedings (Cat. No.02CH37309), 2003
This paper describes the application of a distribution static VAr compensator (DSTATCOM) to an existing industrial facility for voltage flicker mitigation during the starting of a large motor. Traditional methods are discussed for comparison. The performance of these methods and the DSTATCOM are compared using computer-based modeling. Additionally, the
K.N. Choma, M. Etezadi-Amoli
openaire   +1 more source

Harmonic Elimination Using DSTATCOM

2015
There has been an increasing awareness admits customers and utilities regarding superior quality and reliable electric power. The awareness has been triggered by a stupendous increase in the number of nonlinear loads such as power electronic devices. Due to nonlinear loads and low power factor the gravest power quality problems today are voltage sags ...
Shabana Urooj, Pikasha Sharma
openaire   +1 more source

A Multifunctional DSTATCOM Operating Under Stiff Source

IEEE Transactions on Industrial Electronics, 2014
Loads connected to a stiff source cannot be protected from voltage disturbances using a distribution static compensator (DSTATCOM). In this paper, a new control-algorithm-based multifunctional DSTATCOM is proposed to operate in voltage control mode under stiff source.
Chandan Kumar 0001, Mahesh K. Mishra
openaire   +1 more source

Operation and Control of an Improved Performance Interactive DSTATCOM

IEEE Transactions on Industrial Electronics, 2015
This paper proposes an improved performance interactive distribution static compensator (DSTATCOM) to address the limitations of conventional current control mode (CCM) and voltage control mode (VCM) operations. The proposed interactive scheme provides smooth transfer of modes of operation while remaining connected in the distribution system. In normal
Chandan Kumar 0001, Mahesh K. Mishra
openaire   +2 more sources

Performance Analysis of Fuel Cell DSTATCOM

2019 Fifth International Conference on Electrical Energy Systems (ICEES), 2019
The application of Fuel Cell Interfaced Distribution STATic COMpensator (DSTATCOM) for active and reactive power interaction along with harmonic elimination has been discussed in this paper. The energy interfaced DSTATCOM can be used for (i) Harmonic Elimination, (ii) Load Balancing, (iii)Reactive Power Compensation and (iv) Active Power supportduring ...
Pradeep Kumar, Dr. Nagesh Prabhu
openaire   +1 more source

Power compensation by DSTATCOM plus SCESS

2017 4th International Conference on Advances in Electrical Engineering (ICAEE), 2017
The system stability and quality power are the key issues for centralized power system network. In case of integration of distributed generation from conventional and renewable sources to the power system, the stability becomes more vulnerable due to rapid switching, load change and effect of harmonics.
Rajib Baran Roy, Jerome Cros, Enamul Basher, Shahana Akhter   +3 more
openaire   +1 more source

SIFLC based control implementation of DSTATCOM

2018 International Conference on Computer Communication and Informatics (ICCCI), 2018
In this paper, five level distributed static compensator (DSTATCOM) is demonstrated to reduce harmonics efficiently. The topology of the DSTATCOM consists of the cascaded H-hridge multilevel inverter (CHBMLI), de link and interfacing inductor. The dc link voltage regulated with single input fuzzy logic controller.
Dhanavath Suresh, Katabathina Venkateswarlu, S.P. Singh   +2 more
openaire   +1 more source

Power quality improvement using DSTATCOM

2019 Innovations in Power and Advanced Computing Technologies (i-PACT), 2019
This paper presents a combination of voltage source converter and capacitor banks which is called as Static Compensator (STATCOM), voltage source converter (VSC) based diversion connected Flexible AC Transmission System (FACTS) devices which improves the dynamic and static voltage control in transmission in addition with distribution system.
Tanam Karthik, Mummadi Prathyusha, R Thirumalaivasan, M Janaki   +3 more
openaire   +1 more source