Results 51 to 60 of about 668 (183)

Dual-Band High Q-Factor Complementary Split-Ring Resonators Using Substrate Integrated Waveguide Method and Their Applications

open access: yesJournal of Electrical and Computer Engineering, 2019
In modern microwave telecommunication systems, especially in low phase noise oscillators, there is a need for resonators with low insertion losses and high Q-factor. More specifically, it is of high interest to design resonators with high group delay. In
Mehdi Hamidkhani   +2 more
doaj   +1 more source

A Diplexer Bandpass Filter For Dual Band RF Front-End Receiver At 2.4 GHz And 5.75 GHz [PDF]

open access: yes, 2016
A new approach for designing a diplexer for dual-band bandpass filter (BPF) using a parallel coupled microstrip line filter is presented in this paper. The proposed diplexer consists of two fundamental resonant modes and the resonant characteristics has ...
Zahriladha, Zakaria   +3 more
core  

A Wideband Diplexer for Ka-Band Passive Intermodulation Measurement [PDF]

open access: yes, 2018
In this paper we propose a novel Ka-band waveguide diplexer for passive intermodulation (PIM) measurements. Due to the higher operating frequency, this type of measurement setup usually requires wideband filters.
P. Soto   +13 more
core   +1 more source

High‐isolation single‐layer dual‐mode substrate‐integrated waveguide diplexers for millimetre‐wave applications

open access: yesIET Microwaves, Antennas &Propagation, Volume 18, Issue 9, Page 637-645, September 2024.
A high‐isolation single‐layer dual‐mode substrate‐integrated waveguide diplexer for millimetre‐wave applications is proposed. Its equivalent coupling scheme and operating electric‐field distributions in substrate‐integrated waveguide cavity are presented.
Qing Liu   +5 more
wiley   +1 more source

Multi-coupled resonator microwave diplexer with high isolation

open access: yes, 2016
A microwave diplexer achieved by coupling a dual-band bandpass filter onto two single-bands (transmit, Tx and receive, Rx) bandpass filters is presented.
Kenneth S. K. Yeo   +3 more
core   +1 more source

Balanced quasi-elliptic-type combline diplexer with multiextracted-pole junction/output sections [PDF]

open access: yes, 2020
A class of coupled-multiline quasi-elliptic-type balanced diplexer device with closely spaced channels and its balanced coupling-routing-diagram formalism to simultaneously model its differential- and common-mode operation are reported.
Muñoz Ferreras, José María   +2 more
core   +1 more source

Integrating deep convolutional surrogate solvers and particle swarm optimization for efficient inverse design of plasmonic patch nanoantennas

open access: yesNanophotonics, Volume 13, Issue 21, Page 3963-3983, September 2024.
Abstract Plasmonic nanoantennas with suitable far‐field characteristics are of huge interest for utilization in optical wireless links, inter‐/intrachip communications, LiDARs, and photonic integrated circuits due to their exceptional modal confinement. Despite its success in shaping robust antenna design theories in radio frequency and millimeter‐wave
Saeed Hemayat   +3 more
wiley   +1 more source

Microstrip diplexer for recent wireless communities

open access: yes, 2022
The diplexer is a dual-filter circuit with three ports that may share an antenna across two different frequency channels. As long as each band can be employed for sending and receiving signals, this technology can be used for multiple transmitters ...
Al-Majdi, Kadhum, Mezaal, Yaqeen Sabah
core   +1 more source

Low‐loss compact diplexer based on complementary spiral resonators

open access: yesMicrowave and Optical Technology Letters, Volume 66, Issue 6, June 2024.
Abstract The article describes a novel low‐loss microwave diplexer based on compact planar filtering elements. These are composed of spiral resonators and etched directly onto the signal layer. Furthermore, their design and optimization prove to be easy, and their native high‐pass/low‐pass characteristics are perfectly suited for assembling a diplexer.
Giacomo Giannetti, Stefano Maddio
wiley   +1 more source

Design of integrated wideband WR34‐band diplexer‐antenna array module for exploration of monolithic metal 3‐D printing for space applications

open access: yesIET Microwaves, Antennas &Propagation, Volume 18, Issue 4, Page 280-290, April 2024.
The design of a wideband diplexer integrated with a 16‐slot Continuous Transverse Stub (CTS) antenna array is presented. For the preliminary exploration of monolithic metal 3‐D printing of complex geometry integrated RF front ends, two prototypes were manufactured in AlSi10 Mg. One‐piece fabrication eliminates complicated assembly, enhances reliability,
Povilas Vaitukaitis   +3 more
wiley   +1 more source

Home - About - Disclaimer - Privacy