IEEE AccessThe DC-DC converters capable of high gain with bidirectional capability are used in the grid in conjunction with energy storage systems consisting of fuel cells, batteries, and supercapacitors to support the peak load times.
R. Nitheesh +2 more
doaj +1 more source
MOFs and COFs in Electronics: Bridging the Gap between Intrinsic Properties and Measured Performance
Advanced Functional Materials, EarlyView.Metal‐organic frameworks (MOFs) and covalent organic frameworks (COFs) hold promise for advanced electronics. However, discrepancies in reported electrical conductivities highlight the importance of measurement methodologies. This review explores intrinsic charge transport mechanisms and extrinsic factors influencing performance, and critically ...
Jonas F. Pöhls, R. Thomas Weitz
wiley +1 more source
Solid-State Transformers for Interfacing Solar Panels to the Power Grid: An Optimum Design Methodology of a High Frequency Transformer for dc-dc Converter Applications [PDF]
, 2016 Nowadays the use of power electronic interfaces to integrate distributed generation with the power grid is becoming relevant due to the increased penetration of renewable energy sources like solar, and the continued ...
George, Kenny
core +2 more sources
Near‐Infrared Organic Photovoltaic Electrodes for Subretinal Neurostimulation
Advanced Functional Materials, EarlyView.Organic photovoltaic electrodes based on the D18:Y6 blend enable precise and light‐controlled activation of retinal ganglion cells in a degenerating retina. NIR Light‐driven activation of retinal ganglion cells, tunable stimulation parameters, and biocompatibility with human retinal organoids highlight their potential for next‐generation prosthetics ...
Andrea Corna +10 more
wiley +1 more source
Power balancing and dc fault ride through in DC grids with dc hubs and wind farms [PDF]
, 2015 Acknowledgment This project was funded by European Research Council under the Ideas program in FP7; grant no 259328, 2010.Peer ...
Jovcic, Dragan, Lin, Weixing
core +1 more source
Tailoring the Properties of Functional Materials With N‐Oxides
Advanced Functional Materials, EarlyView.The properties of materials bearing N‐oxide groups are often dominated by the polar N+─O− bond. It provides hydrophilicity, selective ion‐binding, electric conductivity, or antifouling properties. Many of the underlying mechanisms have only recently been discovered, and the interest in N‐oxide materials is rapidly growing.
Timo Friedrich +5 more
wiley +1 more source
Active Power Sharing Control in Asymmetrical Bidirectional DC/DC Converter
IEEE Open Journal of Power ElectronicsIn many practical applications, such as electric vehicle charging and smart transformers, reverse power flow is significantly lower than forward power flow.
Lohith Kumar Pittala +5 more
doaj +1 more source
System configuration, fault detection, location, isolation and restoration: a review on LVDC Microgrid protections [PDF]
, 2019 Low voltage direct current (LVDC) distribution has gained the significant interest of research due to the advancements in power conversion technologies. However, the use of converters has given rise to several technical issues regarding their protections
Bououden +11 more
core +1 more source
Advanced Functional Materials, EarlyView.Two‐photon lithography (TPL) enables 3D magnetic nanostructures with unmatched freedom in geometry and material choice. Advances in voxel control, deposition, and functionalization open pathways to artificial spin ices, racetracks, microrobots, and a number of additional technological applications.
Joseph Askey +5 more
wiley +1 more source
Different purpose design strategies and techniques to improve the performance of a dual active bridge with phase-shift control [PDF]
, 2015 This paper addresses the performance of the bidirectional dual active bridge (DAB) converter. One of the advantages of the DAB is the possibility to achieve the zero-voltage switching (ZVS) operation in all the switches of this converter.
González Lamar, Diego +4 more
core +1 more source