Results 11 to 20 of about 1,770 (264)
A Hybrid-Bridge-Based Dual Active Bridge Converter With Reduced Device Count
In this paper, a hybrid-bridge-based dual-active-bridge (DAB) converter with a three-level (TL) half-bridge and a two-level full-bridge is proposed, which can be utilized to interface the medium voltage and low voltage DC.
Jiahui Wu +4 more
doaj +3 more sources
Fuzzy-Adaptive ESO Control for Dual Active Bridge Converters. [PDF]
In converter-dominated direct-current microgrids, severe load transients can cause large voltage deviations on the common direct-current bus. To mitigate this, an energy storage system is typically employed, and an isolated bidirectional dual active bridge converter is commonly used as the power interface.
Seo JH, Choi SJ.
europepmc +4 more sources
Output voltage control of DAB converters based on uncertainty and disturbance estimation [PDF]
The dual active bridge (DAB) converter is a power electronic device commonly used for DC voltage regulation and stabilization. However, during its control process, external disturbances, load variations, input voltage variations, switching tube voltage ...
Haijun Tian +4 more
doaj +3 more sources
An Analysis of a Transformerless Dual Active Half-Bridge Converter
This paper proposes a transformerless dual half-bridge converter (TLDAHB). By eliminating the transformer and harnessing the possibility of using a low inductor value, it is possible to minimise the size of the converter.
Sosnowski Robert +2 more
doaj +2 more sources
Mathematical and simulation modeling of dual active bridge [PDF]
The paper is a structured, in-depth analysis of dual active bridge modeling. In the research new, profound dual active bridge converter (DAB) circuit model is presented.
Roman Barlik +2 more
doaj +1 more source
Dual Active Bridge Converter as Gyrator [PDF]
This work presents the design and control of the DAB converter (Dual Active Bridge) employing gyrator's theory. A brief summary of the theory is introduced, and its application for the DAB converter is verified with a design example. After, is developed the control and show results of simulations and experimental. Thougth the commutation not is studied,
Walbermark M. dos Santos +1 more
openaire +1 more source
In order to control dual active bridge conventionally, control scheme such as single phase shift is used which reduces the system efficiency particularly when voltage conversion ratio differs from unity.
Dharmendra Yadeo +4 more
doaj +1 more source
Modular dual active bridge converter architecture [PDF]
This paper describes a modular1 architecture based on the Dual Active Bridge (DAB) converter in input series, output parallel (ISOP) connection. The work is focused on the input voltage sharing to ensure a proper operation of each module by means of an active control of input and output voltages.
Zumel, Pablo +6 more
openaire +2 more sources
Power Quality Optimization in Dual Active Bridge Converters
The dual active bridge (DAB) converter is widely used in applications such as energy storage systems (ESSs), charging stations, and solid-state transformers. However, input power fluctuations, such as those encountered in photovoltaic systems or fuel cells, may reduce the system’s damping and cause oscillations in the converter’s output ...
Abdul Shakoor +2 more
openaire +2 more sources
Transformer Current Ringing in Dual Active Bridge Converters
In dual active bridge (DAB) converters, there can be transformer current ringing, especially when the transformer turns ratio is high. It is induced by high dv/dt generated by fast switching as well as the low impedance of the magnetic tank at the high-frequency range.
Zian Qin +3 more
openaire +4 more sources

