Results 151 to 160 of about 71,984 (259)

Interface Engineering of Porous Transport Layer‐Catalyst Layer in Proton Exchange Membrane Water Electrolyzers: A Comprehensive Review

open access: yesAdvanced Materials Interfaces, EarlyView.
The PTL–CL interface plays a decisive role in PEMWE performance by governing electron conduction, water supply, oxygen removal, catalyst utilization, and interfacial stability. This review summarizes interface‐related resistance sources, characterization methods, and engineering strategies, highlighting rational PTL–CL interface design for low‐cost ...
Aobo Wan, Zhengkai Tu
wiley   +1 more source

Beyond Local Gating: Toward Network-State-Dependent Neuromodulation. [PDF]

open access: yesBioengineering (Basel)
Belardinelli P   +3 more
europepmc   +1 more source

Hierarchical Multi‐Material Architectures With Gradient Design for Dynamic‐Range Flexible Tactile Sensing

open access: yesAdvanced Materials Technologies, EarlyView.
Hierarchical multi‐material TPMS lattices are engineered as flexible tactile sensors by combining soft and stiff elastomeric layers with a conformal conductive coating. The bilayer architecture delivers sensitivity at low pressures while maintaining a broad detectable range under large loads, enabling reliable pressure and vibration monitoring for ...
Reza Noroozi   +3 more
wiley   +1 more source

Wood‐Derived Nanocellulose‐Biocarbon Fresnel‐Zone Plate Lenses for Sub‐THz Frequency Applications

open access: yesAdvanced Materials Technologies, EarlyView.
Wood‐derived nanocellulose and lignin‐based biocarbon were combined to fabricate fully bio‐based Fresnel zone plate (FZP) lenses for sub‐terahertz frequencies. These sustainable FZP lenses exhibit low dielectric loss and high directivity, achieving performance comparable to that of metallic references, and remain functional under environmental stress ...
Riikka Haataja   +9 more
wiley   +1 more source

Electroencephalography research in neuropathic pain (Review). [PDF]

open access: yesMol Med Rep
Zhou L   +8 more
europepmc   +1 more source

3D‐Printed Dual‐Doped Ag2Se‐Based Thermoelectric Films With Enhanced Thermal Stability

open access: yesAdvanced Materials Technologies, EarlyView.
Sb–Se dual doping enhances the thermal stability of Ag2Se‐based thermoelectric systems. The compositionally tuned nano‐ink is printed into flexible films by direct ink writing (DIW), retaining improved thermoelectric properties after annealing up to 400°C.
Ahasun Habib Hridoy   +8 more
wiley   +1 more source

Programmable Crack Networks for Wide‐Range and Reversible Strain Sensing in Vertically Oriented van der Waals Molybdenum Disulfide Thin Films

open access: yesAdvanced Materials Technologies, EarlyView.
Vertically oriented van der Waals MoS2 thin films enable a mechanically programmable crack network for strain sensing. The initial mechanical programming protocol establishes a programmed crack configuration along weak interlayer and interdomain interfaces.
Yinli Wang, Hiroyuki Hirakata
wiley   +1 more source

Microscale 3D‐Printed Digital Strain Switches for Embedded Mechanical Computation

open access: yesAdvanced Materials Technologies, EarlyView.
Microscale 3D‐printed strain switches on flexible films convert deformation into native digital signals at geometry defined thresholds. A closed form model predicts switching from 3000 to 15 000 microstrain and is validated across 110 devices. Reliable ohmic closure and strain activated AND, OR, and XOR logic point toward low‐power mechanical ...
Regan Kubicek   +3 more
wiley   +1 more source

Home - About - Disclaimer - Privacy