Results 221 to 230 of about 265,109 (310)

Regional variation and prediction model of carbon emissions in the highway construction stage. [PDF]

Sci Rep
Zhang Y, Wang C, Feng S, Ma Q, Mao W, Xu H, Wu Z, Yang D.   +7 more
europepmc   +1 more source

Physics-Enhanced Orthogonal Sensing for Self-Supervised Anomaly Detection in Rolling Mills. [PDF]

Sensors (Basel)
Wang Y, Zheng B, Feng Y, Chen X.
europepmc   +1 more source

ON THE LAW OF MIXTURES IN DUAL-PHASE STEELS

, 1979
openaire   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Atomic-scale observation of hydrogen trap sites in bainite–austenite dual-phase steel by APT

, 2021
It was reported by the thermal desorption analysis (TDA) of hydrogen that bainite–austenite dual-phase steels showed two activation energies of ~30 kJ/mol and ~ 47 kJ/mol under low- and high-fugacity conditions, respectively, and the latter energy ...
J. Takahashi, K. Kawakami, Yuuji Sakiyama, Tomohiko Ohmura   +3 more
semanticscholar   +1 more source

Investigation on micromechanism involved in ferrite hardening after prestraining of dual-phase steel

, 2021
The evolution of low angle grain boundaries (LAGBs) and Taylor factor (TF) was investigated by EBSD analysis to reveal the micromechanism of ferrite hardening for dual-phase steel during prestraining from 1% to 5%.
Nan Wang, Yongnan Chen, Gang Wu, Zhen Zhang, Zhicheng Wu, Jinheng Luo   +5 more
semanticscholar   +1 more source

A new method to produce dual-phase steel

, 2021
In the current research, a new dual-phase (DP) steel produced by a novel technique consists of a combination of friction stir welding (FSW) and austenitization treatment using two different low carbon steels (interstitial free (IF) and St52).
Mohammad Reza Roodgari, Roohollah Jamaati, Hamed Jamshidi Aval   +2 more
semanticscholar   +1 more source

Interphase precipitation of Cu in dual-phase steel

Materials Letters, 2023
Abstract.
Jaromír Dlouhý, Črtomir Donik
openaire   +3 more sources

Properties of Dual Phase Steels

Materials Testing, 2003
Two different heat treatment (intercriticaly and intermediate heat treatments) have been applied to steels containing 0.16% C in order to obtain dual-phase steels (DPS) with different microstructures. One set of intermediate quenched samples were tempered.
Yazici, MURAT, Bayram, A, Durmus, A
openaire   +2 more sources

Fatigue of a dual- phase steel

Metallurgical Transactions A, 1979
A study has been made of the fatigue of a V containing dual-phase steel, whose tensile strength is equivalent to that of SAE 980X high strength, low-alloy (HSLA) steels, as a function of prestrain. It is found that the cyclic stress-strain curve, strain-life response and notch sensitivity are little affected by pre-strains of up to 8 pct: This is in ...
A. M. Sherman, R. G. Davies
openaire   +1 more source

Formability of Dual-Phase Steels

JOM, 1982
The mechanical behavior of dual-phase steels depends on a broad range of metallurgical phenomena. The initial hardening reflects the volume fraction of the martensitic phase via a back stress, but this also depends on the local strength of the martensite.
J. D. Embury, J. L. Duncan
openaire   +1 more source