Results 1 to 10 of about 358 (97)
Bayesian Duval Triangle Method for Fault Prediction and Assessment of Oil Immersed Transformers [PDF]
Dissolved gas analysis of transformer insulating oil is considered the best indicator of a transformer’s overall condition and is most widely used. In this study, a Bayesian network was developed to predict failures of electrical transformers.
Abdelaziz Lakehal, Fouad Tachi
doaj +2 more sources
Machine learning based multi-method interpretation to enhance dissolved gas analysis for power transformer fault diagnosis [PDF]
Accurate interpretation of dissolved gas analysis (DGA) measurements for power transformers is essential to ensure overall power system reliability. Various DGA interpretation techniques have been proposed in the literature, including the Doernenburg ...
Suwarno +3 more
doaj +2 more sources
Abstract Power transformers are among the most important equipment in a power system. The assessment of the transformer’s condition which is connected to a system is needed to avoid disastrous failures and the subsequent power outages.
null Manisha +4 more
openaire +3 more sources
Transformer fault diagnose intelligent system based on DGA methods [PDF]
Power transformers have great importance in power system networks. Any malfunctions in the power transformers cause a system disconnection, which leads to lost profits for the electricity utilities.
Saad A. Mohamed Abdelwahab +3 more
doaj +2 more sources
Analysis of Transformer Conditions using Triangle Duval Method
Abstract Electrical or thermal failure that occurred in the transformer oil can produce a dangerous gas called gas fault. By indicating the content of dissolved gases in the transformer oil, can be obtained information about what happened to the oil so it can be estimated indication of the type and cause of the failure in the transformer.
S Permana, S Sumarto, W S Saputra
openaire +3 more sources
Diagnosis of OLTC via Duval Triangle Method and Dynamic Current Measurement
AbstractPower transformers studies have shown that the main cause of power transformers failures is the On Load Tap Changer (OLTC). OLTC failure occurs due to the insulation degradation and contacts failure inside it. Other than that, contacts wear influences the OLTC performance and this phenomenon has not been deeply investigated.
Khiar, Mohd Shahril Ahmad +4 more
openaire +3 more sources
Transformers are one of the important electrical equipment in the power system. To prevent some electrical contact on the component in transformers, an insulator or dielectric material is needed likely insulating oil.
Muhammad Akmal Afibuddin Putra +3 more
doaj +1 more source
Gas Production by Monoester of Saturated Fatty Acids under Electrical Fault
This paper deals with the gas production by monoester oil intended to be used as insulating oil under an electrical discharge of low energy. The monoester contains only saturated fatty acids in its hydrocarbon chain. The electrical fault was realized by
Abdul Rajab +3 more
doaj +1 more source
Conventional Dissolved Gases Analysis in Power Transformers: Review
Transformers insulated with mineral oil tend to form gases, which might be caused by system faults or extended use. Based on an evaluation of the main failure analysis techniques using combustible gases, this study reviewed the conventional techniques ...
Alcebíades Rangel Bessa +3 more
doaj +1 more source
IOT based classification of transformer faults using emerging techniques of E-nose and ANFIS
E-Nose finds its use in a wide range of applications such as quality assessment in food processing to toxic gas identification in chemical industry either in the offline or online mode.
Md. Danish Equbal +6 more
doaj +1 more source

