Results 1 to 10 of about 503 (205)
ChemElectroChem, 2023 Dynamic electrochemical impedance spectroscopy (dEIS), an extension of conventional EIS, was used for rapid measurements of initiation of localised corrosion on 3005 aluminium alloys with different Mn (1.08–1.39 wt. %) and Cu (0.15–0.22 wt. %) content by
Erlind Mysliu +3 more
doaj +4 more sources
International Journal of Electrochemical Science, 2012 A new technique, which was developed to characterize the direct methanol fuel cell under work conditions, has been presented in this paper. The impedance measurements were made using dynamic electrochemical impedance spectroscopy research technique in ...
Kazimierz Darowicki +2 more
doaj +4 more sources
Electrochemistry Communications, 2021 The interfacial electrochemical characteristics of unpassivated Mg metal electrodes have been studied using Staircase Galvano Electrochemical Impedance Spectroscopy (SGEIS) in THF/C6H5MgCl/AlCl3 solutions over a wide range of applied dc currents.
Ran Attias +4 more
doaj +3 more sources
Modeling Dynamic Electrochemical Impedance Spectroscopy Using a Linearization Technique
ChemElectroChemHerein, the physical modeling of dynamic electrochemical impedance spectroscopy using the example of a redox couple in solution is investigated. While the study of electrochemical systems during operation is of great interest, one is always confronted ...
Cécile Pot d'or +3 more
doaj +2 more sources
EcoMatElectrochemical impedance spectroscopy (EIS), as a non‐invasive and non‐destructive diagnostic technique, has shown unique advantages and significant potential in lithium‐ion battery state monitoring.
Xinyi Zhang +5 more
doaj +2 more sources
Energies, 2021 In order to obtain the full impedance characteristics of a lithium-ion capacitor as a function of temperature, the authors proposed the use of dynamic electrochemical impedance spectroscopy.
Michal Mielniczek +3 more
doaj +1 more source
Electrochemistry Communications, 2021 This paper presents a polynomial description of spectrograms obtained using Dynamic Electrochemical Impedance Spectroscopy. A method to fit the polynomial degree correctly is discussed.
K. Darowicki +4 more
doaj +1 more source
Differential analysis of dynamic immittance spectra
Electrochemistry Communications, 2020 This work presents a new approach to the analysis of immittance spectrograms of systems characterised by non-stationarity. The possibility of linking the evolution of the immittance response with changes in the parameters describing the system is ...
K. Darowicki, A. Zieliński
doaj +1 more source
Dynamic electrochemical impedance spectroscopy, for electrocatalytic reactions [PDF]
Electrochimica Acta, 2014 Abstract Dynamic electrochemical impedance spectroscopy with the ac signal applied while sweeping the potential, is a powerful method to study reaction mechanisms of surface electrochemical reactions. The ability to reliably measure low frequencies while sweeping is key to its successful implementation.
Robert L. Sacci +2 more
openaire +2 more sources
The inhibition effect of mad Honey on corrosion of 2007-type aluminium alloy in 3.5% NaCl solution [PDF]
Materials Research, 2013 The inhibition effect of mad honey on corrosion of 2007-type aluminium alloy in 3.5% NaCl solution was investigated by Tafel extrapolarisation (TP), electrochemical impedance spectroscopy (EIS) and dynamic electrochemical impedance spectroscopy (DEIS ...
Husnu Gerengi +2 more
doaj +2 more sources