Results 11 to 20 of about 11,067,758 (311)
Dynamic Load Test and Contact Force Analysis of the AERORail Structure
The flexible structure of the new type of aerial track studied in this paper is formed by strings and tracks, which have obvious dynamic characteristics under the action of vehicle moving loads and is also an important factor affecting its performance ...
Fangyuan Li +3 more
doaj +1 more source
Testing the superblock deck by dynamic loads
AbstractTyumen oil and gas industry province is being developed with the use of complete block construction. Especially increases the importance of building large blocks with installed equipment and superblocks on a floating mobile base. Styrofoam concrete is used to insulate the superblock deck.
Lyudmila Stefurak, Peter Stefurak
openaire +1 more source
DYNAMIC TESTING OF BRIDGES WITH IMPULSE LOADING
Introduction. This article deals with the practice of applying the method of dynamic testing of bridges, namely, modal control using impulse loading. The possibilities of this method for determining the technical condition of a bridge span structure by determining its natural characteristics: actual stiffness and parameters of natural vibration forms ...
Serhii Zavhorodniy, Vasyl Redchenko
openaire +2 more sources
Analysis of a rapid load test on an instrumented bored pile in clay [PDF]
Rapid load testing methods for piled foundations are generally easier and quicker to mobilise than classic static tests, and are less complex to analyse than dynamic load tests.
Brown, M. J.; id_orcid +2 more
core +1 more source
Dynamic load test is often used for bearing capacity evaluation of driven pile foundation. It is also reported the successful use of this test in bored piles and caissons. This research is mainly concerned with the adaptation, performance and interpretation of the dynamic load test in circular steel plate aiming at the verification of the bearing ...
Luciene S. Moraes +2 more
openaire +1 more source
TILT TEST OF A PALLET LOAD UNIT – SIMULATION STUDIES [PDF]
This paper presents a dynamic model of a palletised load unit during a static tilt test. The stability (also called rigidity) of a load unit was evaluated. The palletised load unit was built of packages forming layers and protected against disintegration
Tomasz MATYJA
doaj +1 more source
Dynamic loading of electric machines during testing
An energy-efficient and simple method of testing electric motors in a dynamic mode is considered. When testing an electrical machine, the rotor is driven into a reciprocating rotary motion. The source of power of the power converter, which controls the electric machine, is a supercapacitor.
Sergey I. Malafeev, Sergey S Malafeev
openaire +2 more sources
Dynamic load balancing of parallel road traffic simulation [PDF]
The objective of this research was to investigate, develop and evaluate dynamic load-balancing strategies for parallel execution of microscopic road traffic simulations.
Igbe, D.
core +1 more source
In order to improve the load state of the two-tooth difference swing-rod movable teeth transmission system, in this paper, a dynamic equivalent calculation model of the transmission system is established based on lumped parameter theory, and then a ...
Rui Wei +4 more
doaj +1 more source
Research on Bearing Capacity of Simply Supported Skew Bridge Based on Load Test [PDF]
The purpose of this paper is to use static and dynamic load tests to evaluate the mechanical performance of a simply supported skew slab bridge and to evaluate its actual bearing capacity.
Li Songhui, Li Honglei, Gao Jinjin
doaj +1 more source

