Results 81 to 90 of about 4,191 (261)
Joint orientation significantly affects P‐wave velocity, with the highest velocity at zero‐degree angles, decreasing to 30° as the angle increases. The velocity increases slightly from 30 to 45 degrees but sharply decreases from 45 to 90 degrees. Abstract Determination of the required parameters in different science contexts using the ultrasonic wave ...
Yaghoob Zarei +4 more
wiley +1 more source
Generation of Seismic Time Histories for Disaster Risk Reduction: A Case Study in the 2nd District of Cagayan de Oro City, Philippines [PDF]
In the 2nd District of Cagayan de Oro City, Philippines, this work describes the construction of a target site-specific response spectrum and the subsequent synthesis of compatible ground motion time-histories for seismic analysis and structural design ...
Israel A Baguhin
doaj +1 more source
Seismic waves with tensile stress, high amplitude, and low frequency are most likely to trigger block instability and sliding. Blocks with a single sliding surface are more prone to movement than those with multiple constraints, and roof‐positioned blocks are especially vulnerable to slide.
Xiao Wang +4 more
wiley +1 more source
This paper explores how climate‐resilient technologies, such as smart grids, digital twins, and self‐healing materials, can enhance urban resilience. It highlights the urgent need for proactive planning, public‐private collaboration, and data‐driven innovation to future‐proof underground infrastructure amid accelerating climate and urban pressures ...
Kai Chen Goh +12 more
wiley +1 more source
A novel shear‐lag model, validated by pull‐out tests, incorporates a constant bond stress stage to predict the complete load–displacement response of grouted rock bolts, providing a new tool for optimizing anchorage length and material toughness in deep underground engineering. Abstract The stability of rock masses in deep underground excavations, such
Wenhui Bian +6 more
wiley +1 more source
B1 is bord width 1, B2 is bord width 2, L is the pillar length, W is the pillar width, red color and letter A represent the pillars, and white color and number 1 represent excavated areas. Pstress is the average pillar stress; σv is the vertical component of the virgin stress, MPa; and e is the areal extraction ratio. e = B o B o + B P ${\rm{e}}=\frac{{
Tawanda Zvarivadza +4 more
wiley +1 more source
This review elucidates the velocity–dispersion–attenuation coupling mechanisms of wave propagation in rock masses, compares six representative models, and reveals how pressure, temperature, mineral composition, and anisotropy jointly control dynamic responses in complex geological media.
Jiajun Shu +8 more
wiley +1 more source
In response to the problem of strong mining pressure manifestation along the goaf roadway in a thick coal seam mining area, this study uses a new type of combined blasting roof cutting technology to effectively control the manifestation and deformation of mining pressure along the goaf roadway.
Xiaoding Xu +6 more
wiley +1 more source
This study demonstrates the feasibility of an underground closed‐loop thermal storage facility at a post‐mining site, intended for seasonal heat energy storage. Its principal design shows water flow directions in winter and summer (1, 2), heat pumps (3), an upper water reservoir (4), and connecting pipes (5).
Dmytro Rudakov, Oleksandr Inkin
wiley +1 more source
Seismic analysis and design of tunnels within fault ground: A review
The research methods of seismic response of tunnels within fault ground, including field investigations, analytical solutions, physical experiments, and numerical simulations, and seismic countermeasures are discussed. The present study examines the shortcomings and limitations of the current research and design, and puts forward proposals for future ...
Xingda Wang +6 more
wiley +1 more source

