Results 71 to 80 of about 173,997 (307)
Results in Physics, 2020 This paper reports on the effects of magnetic and electric properties of a non-stoichiometric composition of cobalt ferrite nanoparticles doped with manganese content at the weight percent 0.25.
M.Z. Ahsan, M.A. Islam, F.A. Khan
doaj +1 more source
PM fractional machines adopting bonded magnets: effect of different magnetizations on the energetic performance [PDF]
, 2012 The adoption of Permanent Magnets in small brushless machines for automotive applications is becoming frequent. Some research on bonded magnets is being carried on to substitute the ferrites.
Ferraris, Luca +3 more
core +1 more source
Interconnected Porous Hydrogels with Tunable Anisotropy Through Aqueous Emulsion Bioprinting
Advanced Functional Materials, EarlyView.A 3D bioprintable microporous bioink is developed using an aqueous two‐phase system (ATPS) composed of extracellular matrix (ECM) mimetic biopolymers. The ATPS bioink enables the fabrication of interconnected porous architectures with up to 70% porosity, supporting long‐term cell viability and 3D cell alignment, enabling a simultaneous generation of ...
Hugo Edgar‐Vilar +4 more
wiley +1 more source
A Novel Flux Focusing Magnetically Geared Machine with Reduced Eddy Current Loss
Energies, 2016 This paper proposes a novel flux focusing magnetically geared (MG) machine for wind power generation, considering the permanent magnets (PMs) eddy current loss and the balance between the pull-out torque of MG machine and the back-electromotive force ...
Jin Liu +4 more
doaj +1 more source
A system identification based approach for pulsed eddy current non-destructive evaluation [PDF]
, 2007 This paper is concerned with the development of a new system identification based approach for pulsed eddy current non-destructive evaluation and the use of the new approach in experimental studies to verify its effectiveness and demonstrate its ...
Agurto, A. +3 more
core +1 more source
Advanced Functional Materials, EarlyView.Reprogrammable multi‐material smart textiles knitted from liquid crystal elastomer fibers undergo 2D and 3D deformation under thermal and photo stimuli. Circularly knitted tubular structures reversibly contract in radial and axial directions, enabling autonomous climbing, liquid release, and micro pumping.
Xue Wan +8 more
wiley +1 more source
Eddy-current loss prediction in the rotor magnets of a permanent magnet synchronous generator with modular winding feeding a rectifier load [PDF]
, 2011 In a permanent magnet synchronous generator (PMSG) with modular winding, significant eddy current may be induced in the rotor magnets due to asynchronous rotating stator magneto-motive forces (MMFs), and a rectifier load may signify the situation further.
Dong, J +4 more
core +1 more source
Advanced Healthcare Materials, EarlyView.Osteoporosis from long‐term glucocorticoid (GIOP) use elevates susceptibility to fracture. This study shows GCs impair ascorbic acid (AA) metabolism in osteoblasts, collagen synthesis and extracellular matrix integrity. AA enhanced collagen biochemical and mechanical properties and restored osteoblast and endothelial function. These findings underscore
Micaila DE Curtis +19 more
wiley +1 more source
IET Electric Power Applications, 2023 It is very important to consider the eddy current reaction of the metal structure in large electric machines, which has a direct impact on the calculation results of induced current and loss.
Erhang Zhu +4 more
doaj +1 more source
Advanced Materials, EarlyView.The Y supersaturation in the [Ba‐Cu(I/II)‐O] transient liquid composition is the driving force toward YBCO nucleation and growth in TLAG. Tuning the initial (Ba:Cu) molar ratio in the ink composition determines the YBCO epitaxial nucleation through supersaturation control.
Lavinia Saltarelli +12 more
wiley +1 more source