Results 121 to 130 of about 9,708 (168)

Distribution of pulmonary ventilation in women with post-COVID-19 before and after the use of a respiratory incentive device (UBICU): a pilot study. [PDF]

open access: yesFront Digit Health
Wilches-Luna EC   +4 more
europepmc   +1 more source

Developing a simple, cost-effective proof-of-concept vaccine candidate against EHEC for cattle. [PDF]

open access: yesPLoS One
Duarte CM   +6 more
europepmc   +1 more source

A fast approach to determine excitation eigenfrequencies for TD-EIT and FD-EIT

Measurement Science and Technology, 2023
Abstract Electrical impedance tomography can reconstruct the complex conductivity distribution by injecting a current or voltage at a specific frequency into the target domain. The complex conductivity spectroscopy of numerous biological tissues is frequency-dependent. A suitable excitation frequency is vital to high-quality imaging over
Yang Li   +6 more
openaire   +1 more source

A Cole phantom for EIT

Physiological Measurement, 1995
A phantom was designed for testing and comparing multifrequency EIT data collection systems. The phantom simulates a cylinder of homogeneous conductor with 16 drive and 16 receive electrodes interleaved. Combinations of resistors and capacitors were used to simulate the complex impedance, Z*, of a typical tissue in the frequency range 8-2048 kHz ...
openaire   +2 more sources

Simultaneous Acquisition of EIT and ECG Signals on Active EIT Electrodes

IEEE Transactions on Biomedical Engineering
This paper introduces a new method of simultaneous acquisition of electrocardiogram (ECG) signals and electrical impedance tomography (EIT) measurements on active electrodes, i.e. electrodes that are applying current, in an EIT system.Howland noise reduction followed by an integrate-and-dump filter and adaptive filtering are used to extract the ECG ...
Ahmed AbdelWahab   +7 more
openaire   +2 more sources

A multifrequency serial EIT system

Physiological Measurement, 1996
A multifrequency (1 kHz-1 MHz) serial electrical impedance tomography (EIT) system has been developed. It is based on 16 active electrodes and can be extended up to 32. Each active electrode can be programmed for current driving and for measuring either the injected current or the voltage difference between adjacent electrodes, and includes calibration
N, Chauveau   +3 more
openaire   +2 more sources

Home - About - Disclaimer - Privacy