Results 201 to 210 of about 2,405 (262)

Intelligent structural microbatteries for adaptive microrobots. [PDF]

Natl Sci Rev
Ma J, Lee SY, Wu ZS.
europepmc   +1 more source

A Modified Polynomial Hysteretic Model for Asymmetric Vertical Hysteretic Behavior of Inclined Rubber Bearings. [PDF]

Polymers (Basel)
Li Z, Chen Y, Xiao Z, Liu B.
europepmc   +1 more source

Beaded metamaterials. [PDF]

Nat Commun
Dreier L, Jones TJ, Plummer A, Košmrlj A, Brun PT.   +4 more
europepmc   +1 more source

Anomalous softening of 3D printed elastomeric foam irradiated under compressive strain. [PDF]

Sci Rep
Maiti A, Small W, Olson TY, Worthington MA, Mabery SL, Saab AP, Lewicki JP.   +6 more
europepmc   +1 more source

Evaluation of the stability of aciclovir in elastomeric infusion devices used for outpatient parenteral antimicrobial therapy. [PDF]

Eur J Hosp Pharm
Sime FB, Wallis S, Jamieson C, Hills T, Gilchrist M, Santillo M, Seaton RA, Drummond F, Roberts J, BSAC OPAT Drug Stability Testing Programme.   +9 more
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

The Analysis of Multilayer Elastomeric Bearings

Journal of Applied Mechanics, 1984
When a multilayer elastomeric bearing is sheared by end loads, the top and bottom surfaces of a typical plate are subjected to a shear stress distribution which causes bending of the plate. A new approach to the analysis of these bearings is presented which systematically takes into account the flexibility and subsequent warping of the plates.
Simo, J. C., Kelly, J. M.
openaire   +1 more source

Condition assessment of in situ elastomeric bearings

IABSE Congress Reports, 2021
<p>Elastomeric bearings used as seismic isolation devices are key elements in the protection of constructions against earthquakes. They enable structures to exhibit very high performances when subject to extreme events, preventing damage both to structural and non-structural components.
Rossi E., D'Amato M., Gigliotti R., Sebastiani M.   +3 more
openaire   +2 more sources

Elastomeric Bearings: State‐of‐the‐Art

Journal of Structural Engineering, 1983
The paper describes the behavior of elastomeric bearings and presents a review of the properties of the elastomer. Results of theoretical analyses and experimental studies are also presented. Potential failure modes, important design criteria, design methods and specifications are described and compared, and their rationale is examined.
Charles W. Roeder, John F. Stanton
openaire   +1 more source

Stability of Elastomeric Isolation Bearings

Structures 2001, 2001
Elastomeric isolation bearings are required to be stable at high shear strains, which occur during strong earthquakes. Hence, rigorous determination of the critical axial load during design is important. Currently the critical load is determined using small displacement Haringx theory and modified to account for large shear strains by an approximate ...
Ian Buckle, Satish Nagarajaiah, Keith Ferrell   +2 more
openaire   +1 more source