Results 261 to 270 of about 13,597 (296)

Experimental Investigation on Fibre Reinforced Elastomeric Bearings

IABSE Reports, 2014
<p> Seismic base isolation by introducing a flexible horizontal layer at the foundation of a structure can significantly reduce the seismic demand. Bearings consisting of elastomeric layers reinforced by thin steel plates or fibre sheets have been used in the past as isolation devises.
Eftychia Apostolid, Alfred Strauss, Stephanos Dritsos, Konrad Bergmeister   +3 more
openaire   +1 more source

Equivalent Homogeneous FE Model for Elastomeric Bearings

Journal of Engineering Mechanics, 1987
An “equivalent homogeneous, orthotropic” model that includes edge effects and an accompanying finite element analysis is presented for elastomeric bearings. The model is developed for three‐dimensional configurations with horizontal layers, and for linear, elastic, small deformation conditions.
Chong K. Lim, Leonard R. Herrmann
openaire   +1 more source

Testing of Elastomeric Bearings for Bridges

2006
The aim of these testings was to determine mechanical characteristics of elastomeric bearings for new Jankomir bridge over Sava river in Zagreb with emphasis on the characteristics in horizontal direction under vertical load. Tested bearings were roun shaped with diameter of 450 mm and total height of 111 mm type V2ES 2400/190 (thickness of elastomeric
Damjanović, Domagoj, Rak, Mladenko, Krolo, Joško   +2 more
openaire   +1 more source

Viscoelastic Stability Model for Elastomeric Isolation Bearings

Journal of Structural Engineering, 1989
A viscoelastic model accounting for the stability effect is proposed for high‐damping elastomeric bearings used in aseismic base isolation. This model is consistent with Haringx's theory, which takes into consideration the significant shear deformation of the elastomer.
Koh, Chan Ghee, Kelly, James M.
openaire   +1 more source

Sensored Elastomeric Bridge Bearing and its Application

Advanced Materials Research, 2010
A prototype of sensored bridge bearing was developed, fabricated, tested and planned to be applied in two bridge structures for sensing and monitoring of construction process and service condition. Besides, numerical modeling of the prototype was performed using the finite element method with ABAQUS, and meanwhile the testing results were calibrated ...
Yi Zhou Zhuang, Gong Kang Fu, Pang Jo Chun, Ji Hang Feng   +3 more
openaire   +1 more source

Elastomeric Sleeve Bearing Design

1972
It is shown that the experimentally determined deflectional behavior of certain elastomer-lined sleeve bearings under static radial loads can be modeled to some extent by the compressive behavior of flat elastomeric slabs. An equation for the thermal bearing-bore change is developed using the conventional theory for the thermoelasticity of ...
openaire   +1 more source

Elastomeric Pads as Bearings for Steel Beams

Journal of the Structural Division, 1961
Discussion of applicability of elastomeric bearings to bridges having steel girders; survey of literature and of data obtained from highway and research agencies on development and use of neoprene ...
openaire   +1 more source

MATHEMATICAL ANALYSIS OF THE LAMINATED ELASTOMERIC BEARING

1966
Abstract : The purpose of this study was the establishment of analytical design procedures for laminated elastomeric bearings. This was approached with the application of the linear mathematical theory of elasticity and later with nonlinear large-deformation elasticity theory.
openaire   +1 more source

Design of elastomeric anti-seismic bearings

2022
I. H. Gregory, A. H. Muhr
openaire   +1 more source

Integrative oncology: Addressing the global challenges of cancer prevention and treatment

Ca-A Cancer Journal for Clinicians, 2022
Jun J Mao,, Msce, Lorenzo Cohen, Karen M Mustian   +2 more
exaly