Results 261 to 270 of about 354,316 (303)
Some of the next articles are maybe not open access.
1972
PhD ; Aerospace materials ; University of Michigan, Horace H. Rackham School of Graduate Studies ; http://deepblue.lib.umich.edu/bitstream/2027.42/187472/2/7306775 ...
openaire +2 more sources
PhD ; Aerospace materials ; University of Michigan, Horace H. Rackham School of Graduate Studies ; http://deepblue.lib.umich.edu/bitstream/2027.42/187472/2/7306775 ...
openaire +2 more sources
2012
An electric arc is formed when a current passes between two conductors through a non-conducting medium like air. Although the phenomenon was discovered during early electrical experiments and utilised widely in lighting by the end of the nineteenth century, its problems were not fully understood. First published in 1902, this book represents one of the
openaire +1 more source
An electric arc is formed when a current passes between two conductors through a non-conducting medium like air. Although the phenomenon was discovered during early electrical experiments and utilised widely in lighting by the end of the nineteenth century, its problems were not fully understood. First published in 1902, this book represents one of the
openaire +1 more source
Modeling of the Electric Arc Behavior of the Electric Arc Furnace
2013During the electric arc furnace operation appear disturbances, which can affect the other equipments that are connected to the same power network. So it is necessary to develop models for the electric arc which characterizes the electric arc behavior in order to identify methods and solutions through which the disturbances that appear in the power ...
Manuela Panoiu +2 more
openaire +1 more source
1989
The tapping of electric furnaces is a hot, physically demanding, and potentially dangerous job. Noise levels often exceed the OSHA limits. To improve the work environment as well as improve productivity, several electric furnaces in Japan worked together with the Tokyo Institute of Technology to develop remote controlled manipulators for tapping.
openaire +1 more source
The tapping of electric furnaces is a hot, physically demanding, and potentially dangerous job. Noise levels often exceed the OSHA limits. To improve the work environment as well as improve productivity, several electric furnaces in Japan worked together with the Tokyo Institute of Technology to develop remote controlled manipulators for tapping.
openaire +1 more source
2006
Abstract Electric arc cutting is used on ferrous and nonferrous metals for rough severing, such as removing risers or scrap cutting, as well as for more closely controlled operations. This article describes the operating principles, equipment selection, process variables, and safety measures recommended for plasma arc cutting and air ...
openaire +1 more source
Abstract Electric arc cutting is used on ferrous and nonferrous metals for rough severing, such as removing risers or scrap cutting, as well as for more closely controlled operations. This article describes the operating principles, equipment selection, process variables, and safety measures recommended for plasma arc cutting and air ...
openaire +1 more source
Integrative oncology: Addressing the global challenges of cancer prevention and treatment
Ca-A Cancer Journal for Clinicians, 2022Jun J Mao,, Msce +2 more
exaly
A-to-Z Guide to Thermodynamics, Heat and Mass Transfer, and Fluids Engineering, 2006
openaire +1 more source
openaire +1 more source