Results 51 to 60 of about 224 (179)

Recycling of Mill Scale Into High‐Purity Iron Through Hydrogen‐Based Reduction

steel research international, EarlyView.
Mill scale, an iron oxide–rich steel by‐product, is difficult to recycle due to impurities. This study evaluates hydrogen‐based direct reduction and hydrogen plasma smelting reduction as low‐carbon recycling routes. Impurity segregation limits reduction kinetics. Direct reduction achieves 92% conversion in 180 min, while plasma reduction reaches 91% in
Nathalia C. Verissimo, Anumoy Ganguly, Lucas Varoto, Tim M. Schwarz, Jean‐Baptiste Letz, Ubaid Manzoor, Laurine Choisez, Dierk Raabe, Isnaldi R. Souza Filho   +8 more
wiley   +1 more source

Development and Validation of a Next‐Generation Mechanistic Model of the Electric Arc Furnace

steel research international, EarlyView.
This study presents a next‐generation mechanistic model of the electric arc furnace (EAF). It describes equations for all crucial processes appearing during the steel‐recycling process in an EAF, i.e., thermal, mass, and chemical. The model was parameterized and validated using industrial EAF data.
Vito Logar, Igor Škrjanc
wiley   +1 more source

Fatigue Behavior Analysis of Asphalt Mixes Containing Electric Arc Furnace (EAF) Steel Slag

Journal of Rehabilitation in Civil Engineering, 2015
This research was conducted in order to evaluate fatigue behavior of asphalt mixes containing Electric Arc Furnace (EAF) steel slag. After initial evaluation of the properties of EAF steel slag using X-ray Diffraction (XRD) and Scanning Electric Microscope (SEM), six sets of laboratory mixtures were prepared.
Kavussi, Amir, Jalili Qazizadeh, Morteza, Hassani, Abolfazl   +2 more
openaire   +2 more sources

Utilization of Renewable Carbon in Electric Arc Furnace-Based Steel Production: Comparative Evaluation of Properties of Conventional and Non-Conventional Carbon-Bearing Sources

Metals, 2023
Conventional (anthracite, calcined petroleum coke, and coke) and non-conventional (biochar, and biocokes (3 wt.% torrefied wood, and 3 wt.% petroleum coke + 3 wt.% charcoal)) carbon-bearing sources have been studied for their use in electric arc furnace (
Lina Kieush, Johannes Schenk, Andrii Koveria, Gerd Rantitsch, Andrii Hrubiak, Horst Hopfinger   +5 more
doaj   +1 more source

Reducing the use of Fossil Carbon and Fuels to Defossilize the Electric Steelmaking Route: Evaluation of the Effects of Alternative C‐Bearing Materials and Hydrogen in the Electric Arc Furnace

steel research international, EarlyView.
The experiments and simulations demonstrate that, in general, alternative carbon sources can decrease fossil CO2 without adversely impacting EAF process and product. High plastics and tires ratios cause unsafe conditions and poor slag foaming. Hydrogen in EAF burners decreases CO2 but increases water vapor, which can raise the hydrogen content in ...
Ismael Matino, Orlando Toscanelli, Antonella Zaccara, Aintzane Soto Larzabal, Asier Zubero Lombardia, Jon Hermosa, Tamara Rodríguez Durán, Valentina Colla   +7 more
wiley   +1 more source

A Novel Approach to Energy Management in Electric Steelworks

steel research international, EarlyView.
Feed‐forward neural networks are exploited to estimate electric energy consumptions of the electric arc furnace and ladle furnace processes. The models are used to optimize production schedule so that more energy intensive grades are produced when the cost of energy is lower.
Valentina Colla, Stefano Dettori, Silvia Cateni, Marco Vannucci, Antonella Vignali, Claudio Mocci, Irene Dovichi, Davide Chionna, Lorenzo Vannini, Enrico Paluzzano, Costanzo Pietrosanti, Davide Onesti, Daniele Venier   +12 more
wiley   +1 more source

Decreasing the Environmental Impact of the Electric Steelmaking Route Through Advanced Modelling Techniques

steel research international, EarlyView.
Ensemble models are adopted to estimate the sterile content of scraps arriving to the scrap yard. Feed‐forward neural networks are exploited to estimate steel composition and temperature after Ladle furnace. The models are validated on data from two steelworks very satisfactory results and are inherently transferable to other steelworks, as they are ...
Valentina Colla, Antonella Zaccara, Stefano Dettori, Laura Laid, Ismael Matino, Silvia Cateni, Teresa Annunziata Branca, Lorenzo Vannini   +7 more
wiley   +1 more source

Modeling the Thermal Properties of Hydrogen‐Based Direct Reduced Iron Using Computational Thermodynamics and Machine Learning

steel research international, EarlyView.
Hydrogen‐based direct reduced iron (H‐DRI) melts differently from scrap and carbon‐bearing DRI. This work combines differential scanning calorimetry experiments, FactSage thermodynamics, and simple composition‐based regression to predict solidus, liquidus, heat capacity, and enthalpy for H‐DRI.
Ankur Agnihotri, Petri Sulasalmi, Pasquale Cavaliere, Ville‐Valtteri Visuri   +3 more
wiley   +1 more source

Removal of Methylene Blue from Aqueous Solution by Using Electrical Arc Furnace (EAF) Slag

Indonesian Journal of Chemistry, 2019
In recent years, environmental protection has gained a major concern. In line with the rapid growth of various industries, high amount of effluent has been generated and discharged to the environment. One of the concerns is the presence of synthetic dye in the wastewater stream, as it may endanger human and aquatic life.
Mohd Suhaimy, Suhanna Natalya, Abdullah, Luqman Chuah   +1 more
openaire   +4 more sources

The Application of Hydrochar Composite Briquettes for Sustainable Slag Foaming in the Electric Arc Furnace Process

steel research international, EarlyView.
Hydrochar‐mill‐scale briquettes with varying C/O molar ratios (0.07–0.90) have been tested at 1650 °C to evaluate their slag foaming performance for electric arc furnace application. All seven briquette recipes developed succeed in promoting slag foaming.
Yu‐Chiao Lu, Andrey Karasev, Björn Glaser, Chuan Wang   +3 more
wiley   +1 more source