Results 301 to 310 of about 80,395 (323)
Some of the next articles are maybe not open access.
Current control in three-phase switching converters and AC electrical machines
Proceedings of IECON'94 - 20th Annual Conference of IEEE Industrial Electronics, 2002In this paper, the design of current control loop and selection of the switching logic for PWM three-phase switching power converters (inverters and rectifiers) and AC electrical machines are presented. The approach is based on the deliberate introduction of the sliding mode motion in the control system.
N. Sabanovic-Behlilovic +3 more
openaire +1 more source
Current mode controlled LCC resonant converter for electrical discharge machining applications
ISIE'2000. Proceedings of the 2000 IEEE International Symposium on Industrial Electronics (Cat. No.00TH8543), 2002In this paper, a contribution to the electrical discharge machining (EDM) technology is presented. The final aim of this research is to develop small size EDM systems and determine the influence of the voltage and current of the output electrical arc on the quality and efficiency of the workpiece machining.
R. Casanueva +3 more
openaire +1 more source
Russian Electrical Engineering, 2020
This paper considers the structure of a multimodal converter intended for electric trains with rotational traction motors. It is shown the consumption of electricity in the upgraded traction electric drive can be reduced and its adjusting properties enhanced in comparison with the standard drive.
A. S. Maznev +3 more
openaire +1 more source
This paper considers the structure of a multimodal converter intended for electric trains with rotational traction motors. It is shown the consumption of electricity in the upgraded traction electric drive can be reduced and its adjusting properties enhanced in comparison with the standard drive.
A. S. Maznev +3 more
openaire +1 more source
2021 IEEE Transportation Electrification Conference & Expo (ITEC), 2021
Medium-voltage electric propulsion is a promising technology to enable the electrification of aircraft, especially for twin-aisle aircraft. The performance of the medium-voltage power converter plays a critical role in the overall electric propulsion performance.
Benjamin Luckett, JiangBiao He
openaire +1 more source
Medium-voltage electric propulsion is a promising technology to enable the electrification of aircraft, especially for twin-aisle aircraft. The performance of the medium-voltage power converter plays a critical role in the overall electric propulsion performance.
Benjamin Luckett, JiangBiao He
openaire +1 more source
IEEE Transactions on Transportation Electrification, 2020
The electric revolution is underway in the transportation sector, and the aviation industry is poised to embrace fundamental disruption. Moving to electric aircraft brings undeniable benefits in terms of environmental impact, cost savings, maintenance, noise pollution, and safety.
Lea Dorn-Gomba +3 more
openaire +1 more source
The electric revolution is underway in the transportation sector, and the aviation industry is poised to embrace fundamental disruption. Moving to electric aircraft brings undeniable benefits in terms of environmental impact, cost savings, maintenance, noise pollution, and safety.
Lea Dorn-Gomba +3 more
openaire +1 more source
Comparative analysis of prospective high-voltage direct current converters of electric locomotive
2013 14th International Conference of Young Specialists on Micro/Nanotechnologies and Electron Devices, 2013Two types of DC-DC converters are compared. These converters are constructed on the basis of a single-phase bridge and a single-phase half-bridge of cells' circuits in the multichannel system. Each channel contains a single-phase VSI, a high-frequency transformer, an active single-phase rectifier on the basis of a turned VSI.
Anna V. Rozhentseva +2 more
openaire +1 more source
Experimental results of electric protections for a controlled current source resonant converter
2010 IEEE International Conference on Industrial Technology, 2010In this paper, the design of electric protections for a controlled current source resonant converter and the corresponding experimental results are presented. This converter was designed for an induction heating current controlled system and is formed by a non-controlled rectifier, a DC-DC buck converter and a current source resonant inverter using ...
R. Fuentes +5 more
openaire +1 more source
Electrical current converted from optically excited spin current
2014A previous work doing in The Hong Kong University (HKU) and The Hong Kong University of Science and Technology (HKUST) showing an electric current is observable upon optically injected spin current at 77K, while a specially designed crossbar structure enables this to happen.
openaire +2 more sources
Currents in bearings of induction motors of electric drives with semiconductor converter
2018 17th International Ural Conference on AC Electric Drives (ACED), 2018The most regular problem of electric drives with semiconductor system is drive electric engine's bearing assembly renny damage. The bearing currents bring a number of damages in drive electric engine. These currents can perform continuous action on the bearing assembly.
Anatolij E. Kozjaruk +3 more
openaire +1 more source
Effect Band Gap of Chitosan Film in Converting Water Vapour Into Electrical Current
Materials Science Forum, 2020In this study, a device called a water vapour cell has been successfully fabricated. A water vapour cell consists of patterned silver on the top layer, chitosan film in the middle, titanium in the bottom layer and isolator substrate as the cover. Chitosan films utilized as a conversion material which works based on direct chemical interactions between ...
Muhammad Balyan +4 more
openaire +1 more source

