Results 111 to 120 of about 741,574 (295)
Through direct application of porous transport layer (PTL) on the bipolar plate (BPP) with thermal spraying, the interfacial contact resistance is improved. With the cold gas sprayed BPP–PTL coating system, a proton exchange membrane water electrolysis cell with a cell voltage of Ucell = 1.9 V can be operated up to i = 2.5 A/cm2 in a dynamic mode ...
Kirsten Bobzin +5 more
wiley +1 more source
Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys
This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa +9 more
wiley +1 more source
This study demonstrates how optimizing laser power, scanning speed, and hatching distance in laser powder bed fusion can boost the productivity of Inconel 718 manufacturing by up to 29% while maintaining mechanical integrity. The work delivers a validated process window and cost–time analysis, offering industry‐ready guidelines for efficient additive ...
Amir Behjat +7 more
wiley +1 more source
Remote judgment of three-phase three-wire electric energy meter wrong wiring
As the data base of electric energy accounting between electric power enterprises and users, the accuracy of electric energy measurement is closely related to the interests of enterprises and users.
WANG Shuyun +4 more
doaj
Advanced control strategy for wind-storage to compensate hammer effect based on SID and FRR
To address the seasonal variations in frequency regulation requirements (FRRs) for a hybrid renewable hydropower system, this study proposes an advanced wind-storage coordinated control strategy to compensate for the water hammer effect, based on system ...
Hongchun Shu +5 more
doaj +1 more source
PLC-based measurement of electrical data in photovoltaic energy systems
Studies made on renewable energy sources have become apparent in the last years with that fossil fuel sources quickly tend to decrease. Among renewable energy sources, intense studies on photovoltaic systems are carried out. In this study, it is mentioned about Programmable Logic Controller (PLC) based data monitoring and controlling system which was ...
Çetin, Engin. +5 more
openaire +6 more sources
EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk +7 more
wiley +1 more source
- Short Term Load Forecasting (STLF) is becoming very important as the use of distributed energy sources, renewable energy, and demand side management increases. Electrical energy is one of the most widely used energy, especially in households.
devan Rozali +2 more
doaj +1 more source
ELECTRICAL ENERGY MEASURING MODUL WITH GALVANOMAGNETIC CURRENT TRANSDUCER
In our time, electrical energy has been used in all household and industrial settings. This is achieved by the ability of the device to convert it into another form of energy – mechanical, lifting, light, heat, and many more. etc., and vice versa.
openaire +1 more source
Micro‐Raman spectroscopy is applied to characterize corrosion products in a recycled‐based MgO–316L steel composite anode after molten salt electrolysis. A depth‐dependent Fe–O/Fe–Al–O layer sequence of magnetite, hercynite, and an Al‐doped magnetite transition zone is identified.
Felix Drechsler +9 more
wiley +1 more source

