Results 71 to 80 of about 741,574 (295)
Advanced Engineering Materials, EarlyView.High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé +5 more
wiley +1 more source
Microwave detection of electron-phonon interactions in a cavity-coupled double quantum dot
, 2017 Quantum confinement leads to the formation of discrete electronic states in quantum dots. Here we probe electron-phonon interactions in a suspended InAs nanowire double quantum dot (DQD) that is electric-dipole coupled to a microwave cavity.
Gullans, M. J. +3 more
core +1 more source
Advanced Engineering Materials, EarlyView.The thermal diffusivity of MgO‐C refractories is highly sensitive to sample preparation and processing procedures. In this article, the effects of coking sequence, machining conditions, structural inhomogeneity, and graphite coating application on measurements using laser flash apparatus are systematically investigated.
Luyao Pan +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Frontiers in Energy ResearchThe integration of a high proportion of renewable energy and power electronic devices in new power systems can trigger wide-frequency oscillation issues.
Runzhi Mu +18 more
doaj +1 more source
Research on Test Method of Ignition Temperature of Electric Explosive Device under Electromagnetic Pulse [PDF]
Radioengineering, 2021 The safety and reliability of electric explosive device, as the most sensitive initiating energy for igniting powder and explosive, directly impact those of weapon system. The safety and reliability of the electric explosion device were determined by the
B. Wang +4 more
doaj
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Influence of an Argon/Silane Atmosphere on the Temperature of a Thermal Plasma
Advanced Engineering Materials, EarlyView.The influence of a silane‐doped argon atmosphere on the chemical composition and temperature of a thermal nontransferring argon plasma is investigated using optical emission spectroscopy. As a result of the high amount of free electrons resulting from the stepwise ionization and dissociation of the silane molecule, even a silane addition of 0.01 vol ...
Lena Kreie +4 more
wiley +1 more source
Capacity Configuration for "PEDF" System Driven by Safe and Stable Operation
Zhongguo dianliPEDF (photovoltaic, energy storage, direct current, and flexibility) is an important support for the new power system to achieve zero carbon electricity in buildings.
Huihong YUAN +5 more
doaj +1 more source
About influence of non-sinusoidal currents and voltages on the amount of the electric energy
MATEC Web of Conferences, 2018 The results of measurements of the harmonics components of the current, voltage, power of harmonics at the point of connection of electric receivers with a non-linear voltage-current characteristic are considered.
Vanin Valery +4 more
doaj +1 more source