Results 41 to 50 of about 902,346 (299)
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Study on the pyrolysis characteristics of styrene-grafted polypropylene cable insulation material
AIP AdvancesPolypropylene (PP) has garnered significant attention as a cable insulation material due to its exceptional electrical performance and recyclability. Styrene-grafted polypropylene (PP-g) emerges as a promising alternative in this context.
Chao Peng +7 more
doaj +1 more source
Science and Technology for Energy TransitionThe construction area of the Sichuan-Tibet Railway is located at a high altitude with thin air conditions, but it benefits from excellent solar irradiance.
Shu Na +4 more
doaj +1 more source
Electric Equipment Diagnosis based on Wavelet Analysis [PDF]
, 2016 Due to electric equipment development and complication it is necessary to have a precise and intense diagnosis. Nowadays there are two basic ways of diagnosis: analog signal processing and digital signal processing. The latter is more preferable.
Kobenko, Yury Viktorovich +3 more
core +1 more source
Advanced Engineering Materials, EarlyView.This study presents an infrared monitoring approach for direct laser interference patterning (DLIP) combined with a convolutional neural network (CNN). Thermal emission data captured during structuring are used to predict surface topography parameters.
Lukas Olawsky +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé +5 more
wiley +1 more source
High VoltageCF4 is a major decomposition product of the insulating gas in C4F7N‐insulated gas‐insulated metal‐enclosed switchgear (GIS) during partial discharge or overheating faults.
Zhicheng Wu +6 more
doaj +1 more source
Ultracapacitors equipped hybrid electric MicroCar
IET Electric Power Applications, 2010 The main purpose of the study is to describe a small size hybrid vehicle having ultracapacitors (UCs) as on-board storage unit. The vehicle on-board main power supply is achieved by a genset being formed of a 250 cc internal combustion engine and a permanent magnet (PM) synchronous electric generator, whereas four 16 V-500 F UCs modules are connected ...
LIDOZZI, ALESSANDRO +2 more
openaire +3 more sources
A fuzzy set approach for reliability calculation of valve controlling electric actuators [PDF]
, 2017 The oil and gas equipment and electric actuators in particular frequently perform in various operational modes and under dynamic environmental conditions. These factors affect equipment reliability measures in a vague, uncertain way.
Efremov, Aleksandr Aleksandrovich +2 more
core +1 more source
Advanced Engineering Materials, EarlyView.The thermal diffusivity of MgO‐C refractories is highly sensitive to sample preparation and processing procedures. In this article, the effects of coking sequence, machining conditions, structural inhomogeneity, and graphite coating application on measurements using laser flash apparatus are systematically investigated.
Luyao Pan +4 more
wiley +1 more source