Results 51 to 60 of about 1,812,133 (300)
Indentation and crush tests are widely used as crash-relevant surrogates for mechanical intrusion in Lithium-Ion Batteries (LIBs), yet their interpretation still relies on macroscopic, binary pass/fail criteria established at the Beginning of Life (BoL).
Richard Polzer +3 more
doaj +1 more source
Battery Crush Test Procedures in Standards and Regulation: Need for Augmentation and Harmonisation
Battery safety is a prominent concern for the deployment of electric vehicles (EVs). The battery powering an EV contains highly energetic active materials and flammable organic electrolytes. Usually, an EV battery catches fire due to its thermal runaway,
Bhavya Kotak +4 more
doaj +1 more source
Fabrication Routes for Ionic Conducting Fiber Strain Sensors
Ionic conducting fiber strain sensors (ICFSs) offer compliant, textile‐integrable sensing. Thus far, the commercialization of ICFSs has been constrained by fiber fabrication routes. This review provides a fabrication‐centric analysis of ICFSs correlating processing strategies with material properties and scalability.
Leo John Kershaw +3 more
wiley +1 more source
Pouch cells in automotive modules age and may experience mechanical abuse while mechanically confined, yet almost all published comparisons of fresh and aged cells release the aging constraint before the abuse test.
Richard Polzer +3 more
doaj +1 more source
Gallium microalloying redirects interfacial reactions in low‐temperature Bi–Sn solders from Cu–Sn toward Cu–Ga intermetallic formation. The resulting Cu–Ga layer suppresses intermetallic growth during thermal aging, alters fracture pathways, and improves interfacial stability.
Iva Králová +6 more
wiley +1 more source
Adaptive Message Generation Rules for V2X Maneuver Coordination Service
Maneuver coordination enables connected and automated vehicles (CAVs) to collaboratively plan, negotiate, and execute driving maneuvers, aiming to enhance safety, traffic flow, and energy efficiency.
Daniel Maksimovski +2 more
doaj +1 more source
This study proposes a potential device design for joint cartilage replacement. Silica‐polytetrahydrofuran (SiO2‐PolyTHF) hybrids with customizable mechanical properties were developed to mimic the characteristics of a natural meniscus. These were synthesized through a two‐pot sol–gel hybrid process.
Yu‐Chien Lin +12 more
wiley +1 more source
The electromobile city: An innovation network approach to urban electric mobility
This paper introduces the innovation network "Electromobile City". Derived from trends affecting future personal mobility, such as an increasing degree of urbanization and the ongoing need for individual mobility, urban regions are identified as ...
Rothfuss, F., Voigt, S., Rose, H.
core +1 more source
Influence of Blind Spot Assistance Systems in Heavy Commercial Vehicles on Accident Reconstruction
Accidents between right-turning commercial vehicles and crossing vulnerable road users (VRUs) in urban environments often lead to serious or fatal injuries and therefore play a significant role in forensic accident analysis.
Thomas König +3 more
doaj +1 more source
The effect of alignment on the electric mobility of soot [PDF]
The effect of an aligning electric field on the mobility of both flame generated smoke and smolder generated smoke was studied. A pulsed differential mobility analyzer was used to study the alignment without changing the DMA flows. No detectable change in the mobility was observed for the smolder smoke, while a small but detectable effect of up to 5 ...
Li, Mingdong +2 more
openaire +1 more source

