Results 31 to 40 of about 563,907 (301)
Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Polarization retention loss in PbTiO3 ferroelectric films due to leakage currents [PDF]
The relationship between retention loss in single crystal PbTiO3 ferroelectric thin films and leakage currents is demonstrated by piezoresponse and conductive atomic force microscopy measurements.
A. Morelli +5 more
core +3 more sources
Influence of an Argon/Silane Atmosphere on the Temperature of a Thermal Plasma
The influence of a silane‐doped argon atmosphere on the chemical composition and temperature of a thermal nontransferring argon plasma is investigated using optical emission spectroscopy. As a result of the high amount of free electrons resulting from the stepwise ionization and dissociation of the silane molecule, even a silane addition of 0.01 vol ...
Lena Kreie +4 more
wiley +1 more source
To address the subjective issue of selecting measurement points based on mainstream line methods for hotspot temperature inversion in oil‐immersed power equipment, this paper demonstrates an oil‐immersed reactor temperature field inversion method based ...
Jiayi Guo +5 more
doaj +1 more source
In this paper, a fast computational method based on the training of the U-net neural network is proposed to solve the fluid-thermal coupling problem of transformers.
Yunpeng Liu +5 more
doaj +1 more source
The design of an electric fence monitoring system : a thesis presented in partial fulfilment of the requirements for the degree of Master of Technology in Production Technology at Massey University [PDF]
This thesis presents the design of an Electric Fence Monitoring System (EFMS) which detects and announciates fence malfunctions indicating operational ineffectiveness. The EFMS consists of a master unit and up to sixteen slave units.
Adamson, Paul Robert
core
Thermomechanical fatigue tests of laser beam powder bed fusion (PBF‐LB) Inconel 718 show that the additively manufactured material reaches almost the lifetimes of conventionally‐rolled material under no‐dwell conditions. Introducing dwell times at the maximum temperature markedly reduces the lifetimes due to pronounced grain boundary sliding associated
Stefan Guth +6 more
wiley +1 more source
This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal +2 more
wiley +1 more source
The interturn paper insulation of oil‐immersed power transformer windings, under the combined influence of electric fields, moisture, and conductor heating, will produce bubbles, which pose a significant threat to the insulation system. However, there is
Chaojie Yang +5 more
doaj +1 more source
The morphologies and velocity of ionic wind induced by direct-current (DC) corona discharge were experimentally measured. DC voltage was applied to short air gaps of high-voltage electrode-needle electrode and grounding electrode-net electrode to ...
Fangcheng Lv +4 more
doaj +1 more source

