Results 71 to 80 of about 2,406,350 (336)

Retracted: Inbound Tourists’ Perception of Tourist Destination Image Classified by UGC Picture Computer Program

open access: yesJournal of Electrical and Computer Engineering, 2023
Journal of Electrical and Computer Engineering
doaj   +1 more source

Genre analysis of introduction section in electrical engineering undergraduate laboratory reports. [PDF]

open access: yesF1000Res, 2022
Veerappan V   +4 more
europepmc   +1 more source

Interaction between Molten Al‐Killed Mn–B Steel and Carbon‐Bonded MgO Refractories Based on Recyclates

open access: yesAdvanced Engineering Materials, EarlyView.
High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé   +5 more
wiley   +1 more source

Retracted: EEG Emotion Recognition Based on Temporal and Spatial Features of Sensitive signals

open access: yesJournal of Electrical and Computer Engineering, 2023
Journal of Electrical and Computer Engineering
doaj   +1 more source

Influence of Sample Preparation and Processing Procedures on the Thermal Diffusivity of MgO‐C Refractories

open access: yesAdvanced Engineering Materials, EarlyView.
The thermal diffusivity of MgO‐C refractories is highly sensitive to sample preparation and processing procedures. In this article, the effects of coking sequence, machining conditions, structural inhomogeneity, and graphite coating application on measurements using laser flash apparatus are systematically investigated.
Luyao Pan   +4 more
wiley   +1 more source

An Intelligent Problem Solving Environment in the Domain of Electrical Engineering [PDF]

open access: green, 2003
Vera Yakimchuk   +4 more
openalex   +1 more source

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

open access: yesAdvanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti   +11 more
wiley   +1 more source

Retracted: Sustainable Development Garden Landscape Design Based on Data Mining and Virtual Reality

open access: yesJournal of Electrical and Computer Engineering, 2023
Journal of Electrical and Computer Engineering
doaj   +1 more source

Home - About - Disclaimer - Privacy