Results 121 to 130 of about 69,256 (287)
Advanced Engineering Materials, EarlyView.The subject of this work is the development of a corrosion‐protective coating on steel sheets for form hardening. Rapid heating in an extreme high vacuum (XHV)‐adequate atmosphere is a useful method to prevent oxidation during alloying of 22MnB5 and aluminum to obtain a metallurgical bonding.
Lorenz Albracht +5 more
wiley +1 more source
Measurement Science and Technology, 2018 Normally, a gas–solids flow should be non-conductive. With the increase in moisture content in a gas–solids flow, the non-conductive flow may become low-conductive. For the measurement of low-conductive materials, i.e. particles with high moisture content, in the pharmaceutical industry, both electrical capacitance tomography (ECT) and traditional ...
Ruican Wang +4 more
openaire +2 more sources
Advanced Engineering Materials, EarlyView.This paper presents a novel approach to reducing oxide layers on metal powders using low‐temperature hydrogen dielectric barrier discharge plasmas at atmospheric pressure. Unlike conventional hydrogen‐plasma reductions, the powders do not contact the plasma directly.
Shukang Zhang +3 more
wiley +1 more source
Assessing the Viability of Complex Electrical Impedance Tomography (EIT) with a Spatially Distributed Sensor Array for Imaging of River Bed Morphology: a Proof of Concept (Study) [PDF]
This report was produced as part of a NERC funded ‘Connect A’ project to establish a new collaborative partnership between the University of Worcester (UW) and Q-par Angus Ltd.
Hill, Graham +4 more
core
Time-lapse capacitive resistivity imaging: a new technology concept for the monitoring of permafrost [PDF]
, 2012 The British Geological Survey, in partnership with the Universities of Sussex and Bonn, is investigating and seeking to prove a new technology concept for the non-invasive volumetric imaging and routine temporal monitoring of the thermal state of ...
Haslam, Ed +6 more
core
Deterministic Detection of Single Ion Implantation
Advanced Engineering Materials, EarlyView.Focused ion beam implantation with high detection efficiencies will enable the rapid and scalable fabrication of advanced spin‐based technologies such as qubits. This work presents the detection efficiencies of a wide range of ions implanted into solid‐state hosts, with efficiencies of >90% recorded for ion species and substrate combinations of ...
Mason Adshead +6 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study reports lightweight polyetherimide triply periodic minimal surfaces lattices coated with carbon nanotube‐reinforced epoxy that combine mechanical robustness with self‐sensing. The conformal coating enhances stiffness, strength and energy absorption while enabling reliable strain monitoring.
A. Triay +3 more
wiley +1 more source
IEEE Open Journal of Instrumentation and MeasurementIn recent years, electrical resistance tomography (ERT) has been successfully applied to map the conductivity of thin-film materials and graphene. Beyond the mapping of static conductivity distribution, ERT is proposed as a new valuable tool for the ...
Alessandro Cultrera +3 more
doaj +1 more source
Short-range ordering in a commercial Ni-Cr-Al-Fe precision resistance alloy
Materials & Design, 2019 Short-range order has been thought to be the primary reason of the abnormal increase of electrical resistivity after aging treatment in the Ni-20Cr based precision resistance alloys.
Yong Wang +6 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Additive manufacturing provides precise control over the placement of continuous fibres within polymer matrices, enabling customised mechanical performance in composite components. This article explores processing strategies, mechanical testing, and modelling approaches for additive manufactured continuous fibre‐reinforced composites.
Cherian Thomas, Amir Hosein Sakhaei
wiley +1 more source