Results 71 to 80 of about 69,256 (287)
Limited Angle Acousto-Electrical Tomography [PDF]
, 2018 This paper considers the reconstruction problem in Acousto-Electrical Tomography, i.e., the problem of estimating a spatially varying conductivity in a bounded domain from measurements of the internal power densities resulting from different prescribed ...
Hubmer, Simon +3 more
core +2 more sources
Arthritis Care &Research, EarlyView.Objective The aim of this study was to determine the differences in demographic, serologic, and clinical characteristics between male and female patients with systemic sclerosis (SSc) in an Australian cohort. Methods This was a retrospective observational study using data from the Australian Scleroderma Cohort Study.
Emily Lin +14 more
wiley +1 more source
Advanced Engineering Materials, Volume 27, Issue 6, March 2025.ErB4 and NdB4 nanostructured powders are produced by mechanochemical synthesis. 5 h mechanical alloying and 4 M HCl acid leaching are used in the production. ErB4 and NdB4 powders exhibit maximum magnetization of 0.4726 emu g−1 accompanied with an antiferromagnetic‐to‐paramagnetic phase transition at about TN = 18 K and 0.132 emu g−1 with a maximum at ...
Burçak Boztemur +5 more
wiley +1 more source
Extended Joint Sparsity Reconstruction for Spatial and Temporal ERT Imaging
Sensors, 2018 Electrical resistance tomography (ERT) is an imaging technique to recover the conductivity distribution with boundary measurements via attached electrodes. There are a wide range of applications using ERT for image reconstruction or parameter calculation
Bo Chen +2 more
doaj +1 more source
, 2014 An electrical impedance spectroscopy-based nondestructive testing (NDT) method is proposed to image both cracks and reinforcing bars in concrete structures.
Ammari, Habib +3 more
core +2 more sources
Pavement testing by integrated geophysical methods: Feasibility, resolution and diagnostic potential [PDF]
, 2017 This work is focused on the assessment of the diagnostic potential of several geophysical methods when applied to the investigation of a rigid airport pavement.
CARDARELLI, Ettore +4 more
core +1 more source
Thermoreflectance Detection of Point Defects Resulting from Focused Ion Beam Milling
Advanced Engineering Materials, EarlyView.Focused ion beam (FIB) milling is a common tool for nanoscale material processing, however irradiation damage, redeposition, and contamination can occur. We use several characterization tools to show FIB‐induced effects beyond 1 mm from the milled area.
Thomas W. Pfeifer +3 more
wiley +1 more source
Computer Tomograph Measurements in Shear and Gravity Particle Flows [PDF]
, 2002 The paper reports the recent results obtained on the applicability of cross-sectional digital imaging method to study particle flow characteristics in 3D particle beds forced to move by gravity or shear.
Bogner, P. +4 more
core
Distinguishability revisited: depth dependent bounds on reconstruction quality in electrical impedance tomography [PDF]
, 2017 The reconstruction problem in electrical impedance tomography is highly ill-posed, and it is often observed numerically that reconstructions have poor resolution far away from the measurement boundary but better resolution near the measurement boundary ...
Garde, Henrik, Knudsen, Kim
core +2 more sources
Advanced Engineering Materials, EarlyView.This study presents a reversible temperature sensor with high switching ratio, ∼103. The device is fabricated using PET‐ITO and carbon nanotube dispersions in alkane. Considering its application in cold chain logistics, a proof‐of‐concept with LED is showcased. Thus, a temperature drop below the threshold temperature (crystallization temperature of the
Sunil Kumar Behera +8 more
wiley +1 more source