Results 71 to 80 of about 119,088 (294)

Thermophysical properties of hot pressed beryllium [PDF]

open access: yes
Experimental measurements of thermal conductivity, electrical resistivity, and specific heat with hot pressed beryllium ...
Tye, R. P.
core   +1 more source

Transport properties of Layer-Antiferromagnet CuCrS2: A possible thermoelectric material

open access: yes, 2010
The electrical, thermal conductivity and Seebeck coefficient of the quenched, annealed and slowly cooled phases of the layer compound CuCrS2 have been reported between 15K to 300K.
A. K. Rastogi   +15 more
core   +1 more source

Tribological Performance of 60NiTi Alloy Under Varying Contact Conditions and Elevated Temperatures in Linear Reciprocating Sliding

open access: yesAdvanced Engineering Materials, EarlyView.
This study investigates the tribological response of 60NiTi alloy under dry, water‐lubricated and high‐temperature conditions. The alloy exhibits decreasing wear volume and friction with increasing temperature due to the formation of protective oxide layers. The work clarifies dominant wear mechanisms and demonstrates the suitability of 60NiTi for high‐
Anthony Onyebuchi Okoani   +2 more
wiley   +1 more source

Effect of Temperature and Nickel Concentration on the Electrical and Dielectric Properties of Polyethylene-Nickel Composites

open access: yesIbn Al-Haitham Journal for Pure and Applied Sciences, 2017
The effect of temperature range from 298 K to 348 K and volume filler content Ñ„ on electrical properties of polyethylene PE filled with nickel Ni powders has been investigated.
Ghassan A. Naeem
doaj  

An experimental investigation of the thermal conductivity and electrical resistivity of three porous 304L stainless steel 'Rigimesh' materials to 1300 K Interim report [PDF]

open access: yes
Thermal conductivity and electrical resistivity measurements for three porous Rigimesh stainless steel materials from 300 to 1300
Tye, R. P.
core   +1 more source

Influence of Zeeman splitting and thermally excited polaron states on magneto-electrical and magneto-thermal properties of magnetoresistive polycrystalline manganite La_{0.8}Sr_{0.2}MnO_3

open access: yes, 2007
Some possible connection between spin and charge degrees of freedom in magneto-resistive manganites is investigated through a thorough experimental study of the magnetic (AC susceptibility and DC magnetization) and transport (resistivity and thermal ...
J. Mucha   +5 more
core   +1 more source

Piezoresistive Monitoring of Carbon Nanomaterial‐Reinforced Epoxy Composites Under Cyclic and Fatigue Loading: A Review

open access: yesAdvanced Engineering Materials, EarlyView.
Carbon nanomaterial‐reinforced epoxy composites exhibit pronounced piezoresistive behavior, enabling intrinsic damage sensing under cyclic and fatigue loading. This review critically compares carbon nanotube and graphene systems, correlating filler content, percolation threshold, and gauge factor with sensing stability and damage evolution.
J. M. Parente   +3 more
wiley   +1 more source

Electromechanical Behavior of Afyonkarahisar Clay Under Varying Stress and Moisture Conditions

open access: yesApplied Sciences
Clay is a widely used material with unique properties that vary depending on water content and applied pressure. In this study, the electromechanical behavior of clay samples from Afyonkarahisar, Turkey, is investigated by examining the relationship ...
Ahmet Raif Boğa   +3 more
doaj   +1 more source

Analysis of the relationship between electrical resistivity, hydraulic conductivity and physico-chemical parameters for the Aquifer Free of the Corumbataí (SP)

open access: yesRevista Águas Subterrâneas, 2017
Brazil is a privileged country in relation to their mineral resources, but have problems in diagnosis the situation about the surface water and groundwater, because the quality and the quantity of water.
Fernanda Teles Rosa   +3 more
doaj   +1 more source

Thermal conductivity and electrical resistance of carbon-based cementitious composites

open access: yesMagazine of Concrete Research
The aim in this study was to produce multifunctional cementitious composites with advanced thermal and electrical performance, considering that these composites have high conductivity and can be used in, for example, deicing, electromagnetic shielding, antistatic or anticorrosion applications.
Acikok, Fatih   +5 more
openaire   +2 more sources

Home - About - Disclaimer - Privacy