Results 181 to 190 of about 3,955,580 (331)
Exploring carbon nanotube-copper composites for enhanced induction motor design in electrical vehicles. [PDF]
Akbar H +6 more
europepmc +1 more source
Scalable manufacturing challenges and limited potency remain two of the most intransigent issues limiting clinical translation of EV therapeutics. Mechanical cues can induce phenotypic changes and increased vesiculation in EV source cells without the use of extraneous reagents, chemicals, and/or cargo, thereby potentially drastically improving the ...
Emily H. Powsner +10 more
wiley +1 more source
New insights into improving acidic aluminum fuel cell for powering electrical vehicles. [PDF]
Alazmi ML, Alsubaie MS, Fetouh HA.
europepmc +1 more source
Anti‐Slip Material‐Based Strategies and Approaches
This review highlights the principle mechanisms of slipping at the microscale, linking contact mechanics with a friction behavior model for surface interfaces. Main strategies to develop anti‐slip properties to the surfaces are discussed alongside standardized testing approaches.
Sogand Abbaspoor‐Zanjani +3 more
wiley +1 more source
Base Oils and Formulated Transmission Oils for Electrical Vehicles: Thermophysical and Tribological Properties. [PDF]
Liñeira Del Río JM +4 more
europepmc +1 more source
Optofluidic Raman Analysis and Capacity Recovery in Li‐ion Cells
Operando Raman spectroscopy is used to monitor the degradation of commercial Li‐ion cells. Using a microfluidic access port, small amounts of electrolyte are sampled into a hollow‐core optical fibre, where fibre‐enhanced Raman analysis reveals Li+ solvation changes and solvent evolution.
Ermanno Miele +9 more
wiley +1 more source
Electrical vehicles impact on unbalanced distribution networks considering different loads and energy prices. [PDF]
Sadat SMAM +2 more
europepmc +1 more source
In this study, we report a resistive‐type strain sensor fabricated using single‐walled CNTs, are used layer using the pray technique to deposit as conductive, and UV‐resin was spin‐coated as a protection layer. The sensor functioned in harsh temperature variation conditions from −50°C to 125°C without deterioration.
Jagan Singh Meena +4 more
wiley +1 more source
Frequency regulation of interconnected hybrid power system with Assimilation of electrical vehicles. [PDF]
Daraz A +5 more
europepmc +1 more source
Hierarchically microarchitected PLA/S/CNT cathodes are fabricated via scalable fused filament 3D printing as high‐sulfur‐loading hosts for rechargeable lithium–sulfur batteries. The assembled Li–S cells with sulfur loadings up to 17 mg cm−2 deliver an areal capacity of 9.2 mAh cm−2 and retain 96% of their discharge capacity after 100 charge–discharge ...
Vinay Gupta +4 more
wiley +1 more source

