Results 21 to 30 of about 245,217 (267)
Analysis of experimental results of a Pressurized Solid Oxide Fuel Cell System simulating a Hybrid Power Plant [PDF]
The low-carbon economy of the future needs low consumption of fossil and high quality renewable based fuels. This requires high efficiencies, good part-load performance and fuel flexibility.
Metten Matthias +3 more
doaj +1 more source
Hydrogen‐Assisted Fracture of Iron‐Based Fe–Ni–Al Alloys
Principal relations and fracture mechanisms of single‐phase and precipitate‐strengthened Fe–Ni–Al alloys subjected to prior electrochemical hydrogen charging are identified. The mechanisms of hydrogen effect on strength and microhardness are discussed, including hydrogen‐induced increase in microhardness and the role of hydrogen in fracture behavior ...
Nataliya Yadzhak +3 more
wiley +1 more source
Electrocatalytic recycling of waste nitrate to NH3 under ambient conditions maybe an appealing alternative to the Haber−Bosch process. Here the authors report a tandem catalyst system involving cooperative adsorption of reaction intermediate on different
Wenhui He +8 more
doaj +1 more source
The frequency-dependent impedance of a metal/oxide/room temperature ionic liquid (RTIL) interface was separated into oxide layer (Cox) and double layer (Cdl) capacitances using electrochemical impedance spectroscopy (EIS).
Junsoo Han +4 more
doaj +1 more source
Current Status and Challenges in Data Collection for Aerospace Coatings Deposited by Plasma Spraying
An innovative approach has been integrated into the GRENAT project to optimize plasma spraying and coating performance. Raw materials are accelerated and melted in the plasma generated by torches, creating coatings. Monitoring sensors collect process data which are combined with ex situ characterization data.
Lila Randriamananjara +8 more
wiley +1 more source
Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
This study applies machine learning regression to predict chromium layer thickness in decorative trivalent chromium electroplating, using 441 experiments from laboratory‐scale (1L) and pilot‐scale (14L) setups. Tree‐based models, particularly CatBoost, outperformed linear regression by capturing nonlinear parameter interactions (R2$R^2$ up to 0.77 ...
Christoph Baumer +4 more
wiley +1 more source
Designing a versatile and rational method for the tactical tuning of the surface and interfacial properties of graphene is an essential yet challenging task of many scientific areas including health care, sensors, energy, and the environment.
Chiranjeevi Srinivasa Rao Vusa +4 more
doaj +1 more source
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal +3 more
wiley +1 more source
Enhancing Lithium‐Metal Battery Safety and Performance with Ether‐Aided Ionic Liquid Electrolytes
Electrolytes based on ionic liquids (ILs) are promising alternatives to conventional electrolyte systems due to their appealing properties, including enhanced safety owing to their high thermal stability and nonflammability, as well as their superior ...
Ziyuan Lyu +5 more
doaj +1 more source

