Results 231 to 240 of about 17,378 (266)
Some of the next articles are maybe not open access.
Electrochemical corrosion behavior of Al18B4O33w/Al composite
Journal of Materials Science, 2005The effects of the volume fraction of alumina borate (Al18B4O33) whisker and the scan rate of potentiodynamic technique on the localized corrosion behaviors of Al18B4O33w/Al composite were investigated. Potentiodynamic polarizations and cyclic polarizations were performed to examine the electrochemical corrosion behavior of the composites.
J. Hu, K. Tian, W. Y. Chu
openaire +1 more source
Electrochemical corrosion behavior of nanocrystalline copper bulk
Materials Science and Engineering: A, 2007Abstract The corrosion behavior of nanocrystalline (nc) copper bulk prepared by IGCWC (inert gas condensation and in situ warm compress) was studied in 0.1 mol/L CuSO 4 + 0.05 mol/L H 2 SO 4 solution. It was found that nc copper exhibited a corrosion behavior quite different from conventional coarse-grain copper.
W. Luo, C. Qian, X.J. Wu, M. Yan
openaire +1 more source
Electrochemical corrosion behaviors of amorphous Co69Fe4.5Ni1.5Si10B15 alloy
Metals and Materials International, 2011The corrosion behavior of an amorphous Co69Fe4.5Ni1.5Si10B15 alloy ribbon was examined as a function of solution temperature (15 °C to 55 °C) and pH (3 to 11). The results of potentiodynamic polarization tests in H2SO4 solution, NaCl solution, and HCl + NaOH solution at various levels of pH showed that the corrosion resistance for the alloy ribbon ...
Hyun-Goo Kim, HeeJin Jang
openaire +1 more source
Electrochemical Corrosion Behaviors of Nuclear Waste Package Materials
CORROSION 2021, 2021Abstract The corrosion rates of alloys that will be present in spent fuel waste packages are being measured to represent the generation rates of H2 in a breached package under a range of Eh-pH conditions. The H2 concentration is a crucial parameter in repository performance analyses because the presence of even small amounts of H2 in a ...
V.K. Gattu +4 more
openaire +1 more source
The effect of medium on the corrosion and electrochemical behavior of nickel
Protection of Metals, 2007Electrochemical and corrosion properties of nickel in neutral, alkaline, and acidic solutions are studied. Chemical and phase composition of surface films and surface morphology are examined. The effect of electrolyte composition and concentration on the metal removal rate in the course of broaching is determined.
V. V. Parshutin +2 more
openaire +1 more source
The Electrochemical and Corrosion Behavior of Aluminum
1970Abstract : The electrochemical behavior of high-purity aluminum was studied to clarify the corrosion behavior of the metal when exposed to oxygen-free and oxygen-saturated saline solutions of varying pH. The mixed or corrosion potential, E sub M, of the electropolished high-purity aluminum decreases as the pH is increased except in the intermediate pH ...
openaire +1 more source
Electrochemical corrosion and mechanical behaviors of the charged magnesium
Materials Science and Engineering: A, 2008Abstract The electrochemical corrosion and mechanical behaviors of the charged magnesium were investigated using Mott–Schottky (M–S) test and slow strain rate test (SSRT), respectively. The results showed that the hole carrier and vacancy concentrations in the corrosion film increased after cathodic charging due to the formation of magnesium ...
Jian Chen +3 more
openaire +1 more source
Understanding Corrosion Behavior from Electrochemical Measurements
CORROSION 2004, 2004Abstract Results of immersion tests are often used in selecting structural materials for corrosive applications. This may be dangerous if the effects of varying impurities are not fully assessed. The assessment could be difficult to achieve from results of immersion tests.
openaire +1 more source
Electrochemical Corrosion Behavior of Corrosion-Resistant Steel for Cargo Oil Tank
Advanced Materials Research, 2013Electrochemical corrosion behavior of corrosion-resistant steel for cargo oil tank were studied under different immersion corrosion time, and tests were carried in the PH=0.85, 10% NaCl solution, which temperature were 30°C. The electrochemical tested by the electrochemical polarization curve and electrochemical impedance spectroscopy (EIS), and the ...
Jing Xu, Jian Wei Yang, Jian Ping Cao
openaire +1 more source
Electrochemical Corrosion Behavior of Powder Metallurgy Ti6Al4V Alloy
Journal of Materials Engineering and Performance, 2020The corrosion behavior of powder metallurgy (PM) Ti6Al4V alloys with different relative densities ranged from 95.2 to 99.5% is investigated in 3.5 wt.% NaCl solution at room temperature by electrochemical methods, including potentiodynamic polarization curves and electrochemical impedance spectroscopy.
Yang Zhou +5 more
openaire +1 more source