Results 51 to 60 of about 95,938 (262)
Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
One of the goals of this research was to develop an electrochemical sensor that had the ability to determine the target analyte and was both cheap and non-toxic. Another goal was to influence the reduction of electronic waste. In accordance with these, a
Žaklina Z. Tasić +5 more
doaj +1 more source
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal +3 more
wiley +1 more source
Electrified Damage in Motion Systems
The electrified damage in motion systems is a fundamental framework presenting the degradation pathway arising from the coupling of electrical energy transport with mechanical contact and interfacial chemistry. The framework positions electrified damage as a distinct degradation regime with unique characteristic surface morphologies and failures of ...
M. Humaun Kabir +2 more
wiley +1 more source
Active Corrosion Protection of Sintered AA7075 Aluminum Alloy via Mn Powder Addition
AA7075 containing Mn‐rich particles is fabricated via spark plasma sintering using AA7075 and Mn powders. Corrosion resistance is evaluated through dip‐and‐dry tests using 0.1 M NaCl (pH 6.0), and mass loss decreases with increasing Mn addition. Mn‐rich particles function as a source of Mn ions, and formation of Mn‐accumulation films on Cu‐containing ...
Ko Ebina, Masashi Nishimoto, Izumi Muto
wiley +1 more source
Electrochemical behaviors and electrochemical determination of carbamazepine at ionic liquid modified carbon paste electrode in the presence of sodium dodecyl sulfate [PDF]
The electrochemical behavior and electrochemical determination of carbamazepine (CBZ) at hydrophobic ionic liquid 1-Benzyl-3-Methylimidazole hexafluorophosphate ([BnMIM]PF6) modified carbon paste electrode ([BnMIM]PF6/CPE) in the presence of sodium ...
Liu Li-Hong +2 more
doaj +1 more source
On the Electrochemical Oxidation of Resveratrol [PDF]
AbstractResveratrol (3,5,4′‐trihydroxystilbene) is an organic metabolite produced by plants in response to fungal infection. It is found in various plant fruits and is abundant in the skins of unripe grapes and related products. This photosensitive molecule exists in two isomeric forms, trans and cis‐resveratrol. The antioxidant activity of resveratrol,
Corduneanu, Oana +2 more
openaire +2 more sources
High‐Resolution Corrosion Fingerprinting of Alloy Libraries via Microdroplet Spectroelectrochemistry
Ionic‐liquid microdroplet spectroelectrochemistry enables stable, localized electrochemical measurements over extended timescales. By coupling impedance spectroscopy, wetting analysis, finite‐element simulations, and operando Raman spectroscopy, it disentangles geometrical and electrochemical effects, opening new opportunities for rapid corrosion ...
Ekaterina Kurchavova +3 more
wiley +1 more source
Laser‐Induced Graphene from Waste Almond Shells
Almond shells, an abundant agricultural by‐product, are repurposed to create a fully bioderived almond shell/chitosan composite (ASC) degradable in soil. ASC is converted into laser‐induced graphene (LIG) by laser scribing and proposed as a substrate for transient electronics.
Yulia Steksova +9 more
wiley +1 more source
The biodegradability of fermentation pharmaceutical wastewater is poor. A diaphragm electrochemical coupling Fenton oxidation process was constructed to replace the conventional Fenton oxidation pretreatment of fermentation pharmaceutical wastewater ...
QIN Wei
doaj +1 more source

