Results 31 to 40 of about 39,522 (263)
The magnetic suspension wind tunnel balance (MSBS) is an entirely new device for aerodynamic measurement, and it makes the best of the electromagnetic force to suspend the aircraft model in the wind tunnel without contact. Compared with conventional wind
Mingda Zhai +3 more
doaj +1 more source
Experimental study on response of carbon fiber composite with fasteners under lightning strike
Composite is widely used in aircraft structure, and its lightning protection methods are becoming increasingly mature, but the research on conducted lightning current at the joint of metal fasteners and composite is still incomplete.
YAO Junjun, LI Dan, HE Zheng, XIONG Xiu
doaj +1 more source
With the continuous proliferation of radio frequency devices, electromagnetic environments in various regions are becoming increasingly complex. Effective monitoring of the electromagnetic environment and identification of interference sources have thus ...
Yuanqiang Sun +6 more
doaj +1 more source
Forces of Shift of the Electromagnetic Motor
There have been analyzed shift forces operating in the linear electromagnetic motor and it was disclosed that in a general case there are operating the components of three forces, and one force from them is the one that is functioning longitudinally to the horizontal axis and is considered to be useful force of attraction and there has been evaluated ...
Matkevičius, Edvardas +1 more
openaire +2 more sources
In order to get the better electromagnetic characteristics of the micro digital valve, the larger electromagnetic force should be obtained in the smaller electromagnetic structure.
Meisheng Yang, Junhui Zhang, Bing Xu
doaj +1 more source
Current Status and Challenges in Data Collection for Aerospace Coatings Deposited by Plasma Spraying
An innovative approach has been integrated into the GRENAT project to optimize plasma spraying and coating performance. Raw materials are accelerated and melted in the plasma generated by torches, creating coatings. Monitoring sensors collect process data which are combined with ex situ characterization data.
Lila Randriamananjara +8 more
wiley +1 more source
Design and Analysis of Compression–Torsion Coupling Metamaterials Using the Golden Section Method
A novel compression–torsion metamaterial is engineered using inclined rods and symmetry breaking. To optimize its torsional performance, the golden section method is employed. The mechanical response of the metamaterial is validated through both numerical analysis and experimental validation.
Amirhossein Hassani, Sara Bagherifard
wiley +1 more source
ABSTRACT Electronic waste has emerged as a major environmental challenge, driven by the massive consumption and a limited lifetime of modern electronic devices, stimulating the development of sustainable electronics. Here, an all‐biomaterial gelatin‐choline‐citric acid ([Ch][CA]) ionogel is developed as an active binder to realize self‐sintered ...
Lin Guo +10 more
wiley +1 more source
A three‐dimensional magnetic field sensor is realized in chiral W/CoFeB/MgO multilayers, where spin–orbit torques reversibly reconfigure homochiral stripe domains. The symmetry of the torque enables offset‐free in‐plane sensing, while the reproducible domain reconfiguration extends the linear out‐of‐plane range. An anomalous Hall readout delivers large‐
Sabri Koraltan +16 more
wiley +1 more source
Electrodynamic Contact Bounce Induced by Fault Current in Low-Voltage Relays
Due to fault currents occurring in electrical installations, high electromagnetic force values may be induced in current paths of low-voltage electromagnetic relays. This force may lead to an electromagnetic bounce that will further result in an electric
Andrzej Ksiazkiewicz +3 more
doaj +1 more source

