Results 51 to 60 of about 87,042 (291)
An In Depth Study into Using EMI Signatures for Appliance Identification
, 2014 Energy conservation is a key factor towards long term energy sustainability. Real-time end user energy feedback, using disaggregated electric load composition, can play a pivotal role in motivating consumers towards energy conservation. Recent works have
Jain M. +7 more
core +1 more source
A three-switch high-voltage converter [PDF]
, 1999 A novel single active switch two-diodes high-voltage converter is presented. This converter can operate into a capacitor-diode voltage multiplier, which offers simpler structure and control, higher efficiency, reduced electromagnetic interference (EMI ...
Pietkiewicz, Andzrej +2 more
core +1 more source
Real‐Time 3D Ultrasound Imaging with an Ultra‐Sparse, Low Power Architecture
Advanced Healthcare Materials, EarlyView.This article presents a novel, ultra‐sparse ultrasound architecture that paves the way for wearable real‐time 3D imaging. By integrating a unique convolutional array with chirped data acquisition, the system achieves high‐resolution volumetric scans at a fraction of the power and hardware complexity.
Colin Marcus +9 more
wiley +1 more source
Interference of Spread-Spectrum Modulated Disturbances on Digital Communication Channels
IEEE Access, 2019 In this paper, the effects of random spread spectrum (SS) electromagnetic interference (EMI) on digital communications are addressed. For this purpose, the influence of EMI on a communication channel is described in the framework of information theory in
Francesco Musolino, Paolo S. Crovetti
doaj +1 more source
A simple model of EMI-induced timing jitter in digital circuits, its statistical distribution and its effect on circuit performance [PDF]
, 2003 A simple model has been developed to characterize electromagnetic interference induced timing variations (jitter) in digital circuits. The model is based on measurable switching parameters of logic gates, and requires no knowledge of the internal ...
Fischer, K. +3 more
core +1 more source
Advanced Materials, EarlyView.A 3D‐printable dual‐mode radiation shielding material is introduced by combining boron nitride nanotubes and single‐walled carbon nanotubes in a stretchable PDMS matrix. The complementary nanotube network enables simultaneous attenuation of electromagnetic interference and neutron radiation while maintaining lightweight, mechanical resilience, and ...
Flandy +12 more
wiley +1 more source
An uncommon cause of inappropriate ICD shock
Clinical Case Reports, 2020 In cases of electromagnetic interference (EMI), if the source of the inappropriate EMI cannot be identified, then the sensitivity of the device could be decreased, or the cycle length of the VF detection trigger zone changed.
George Bazoukis +7 more
doaj +1 more source
Systematic Electromagnetic Interference Filter Design Based on Information From In-Circuit Impedance Measurements [PDF]
, 2010 Based on a two-probe measurement approach, the noise source and noise termination impedances of a switched-mode power supply (SMPS) under its normal operating condition are measured.
Canavero, Flavio +3 more
core +1 more source
Advanced Materials, EarlyView.Precursor carbon stoichiometry programs internal strain and oxygen substitution in Ti3AlCxO2‐x, deterministically switching Ti3CxO2‐xTz MXenes between highly aligned 2D nanosheets and spontaneous 1D nanoscrolls. This synthesis‐stage architecture control enables ultrathin X/W‐band EMI shielding with outstanding mass‐normalized performance and bending ...
Jaeeun Park +12 more
wiley +1 more source
Electromagnetic Shielding Properties of Pack Borided MirraxTM Steel
Sakarya Üniversitesi Fen Bilimleri Enstitüsü Dergisi, 2021 In this study, it was aimed to investigate the electromagnetic interference shielding (EMI-SE) as well as some physical and mechanical properties of pack borided Mirrax tool steel.
İbrahim Altınsoy
doaj +1 more source