Results 101 to 110 of about 18,429,976 (289)
Optoelectronic synaptic devices based on solution‐processed molecular telluride GST‐225 phase‐change inks are demonstrated for three‐factor learning. A global optical signal broadcast through a silicon waveguide induces non‐volatile conductance updates exclusively in locally electrically flagged memristors.
Kevin Portner +14 more
wiley +1 more source
Fully additive vertical organic electrochemical transistors (vOECTs) with channel‐length of 226 nm on a 50 µm compostable substrate achieve >106 current modulation and ∼36 mS transconductance. Ion‐selective integration enables 1.1 mA dec−1 sensitivity and 36 µm detection limit, highlighting a scalable platform for sustainable electronics and ...
Giulia Frusconi +3 more
wiley +1 more source
Experimental study on Camless compressed air engine port timing using electronic control unit
This research paper presents an experimental study conducted on an air engine with an electronic control unit (ECU) to investigate the influence of inlet pressure on port timing.
Nikhilkumar Jagjivanbhai Chotai +1 more
doaj +1 more source
Ferroelectric tunnel junction devices based on epitaxial undoped ferroelectric HfO2 films demonstrate stable switching endurance of over 106 switching cycles, low write voltages of ±3 V, 16 measured resistance states, and neuromorphic capability.
Markus Hellenbrand +13 more
wiley +1 more source
Advances in Sustainable and Wearable Textile Based Soft Robotics
This Review examines advances in wearable textile‐based soft robotics, focusing on sustainable materials, integrated sensing, and scalable actuation. It discusses manufacturing and system integration across healthcare, assistive robotics, prosthetics, and human–machine interfaces, and highlights key challenges in circular design, including life‐cycle ...
Zahir Abbas +6 more
wiley +1 more source
This thesis studies the problem to measure and control signals on a Volvo L110G wheel loader without interfering with the original Electronic Control Units.
Häggström, Fredrik
core +1 more source
Integration of the Test Mode Into the Electronic Control Unit for End-of-Line Testing
This study experimentally evaluated three firmware flashing and testing strategies used in automotive Electronic Control Units (ECUs) during serial production: (i) a simplified test-oriented firmware executed in Virgin Mode, (ii) a Dual-Bank Production ...
M. Horak
doaj +1 more source
Structure‐Guided Dynamical Mechanics in Bioinspired Double Twisted Laminated Thin Films
This work explores a dynamic mechanistic study of crack propagation and puncture testing via real‐time monitoring of crack initiation, propagation, and termination through nature‐inspired single and double twisted architectures fabricated from cellulose nanocrystals.
Justin Brackenridge +4 more
wiley +1 more source
Bio‐Inspired Synthesis of Macroporous Single Crystal Particles as Scattering Agents
A general strategy is presented that delivers unique, single‐crystal microparticles that combine submicron macroporosity and uniform particle shapes. A bioinspired approach is used to occlude three distinct types of additives – polystyrene microspheres, polymer vesicles and amino acids – within calcite single crystals, and subsequent thermal annealing ...
Stephanie E. Foster +11 more
wiley +1 more source
Electronic Control Unit for Automatic Control of Torque Vectoring
Torque vectoring for automobiles is used to increase cornering speeds and improve road safety by manipulating the car's wheel-speeds. One method of torque vectoring for a rear-wheel-drive Formula Student race car is using a dual-clutch to slip the inner ...
Huzell, John, Göransson, Johan
core

