Results 61 to 70 of about 410 (183)
Teshugang, 2023 The continuous cast round bloom of DZ2 high-speed axle steel is remelted by electroslag with argon protective atmosphere and rolled into axle billets. The composition, hydrogen and oxygen content and the number, size and morphology of inclusions in the ...
邬中华 +4 more
doaj
Production Practice of Raw Materials for Ultra-Low Carbon Stainless Steel 316L Ultra-Fine Wire
Teshugang, 2012 The raw material of stainless steel 316L (/%: ≤0.03C, ≤ l.0Si, ≤2.0Mn, ≤0.035P, ≤0.030S, 16~18Cr, 12~15Ni,2 ~3Mo) meeting the requirement for production of 00.018 mm ultra-fine wire is successfully produced by 11 3-phases electroslag furnace with lining ...
李刚頒 +5 more
doaj
TeshugangBased on the laboratory small-scale low-frequency electroslag remelting device， taking 70%CaF2+30%Al2O3 electroslag remelting 304L austenitic stainless steel as the research object， we analyze in detail the influence of different remelting current on the
Wang Bingjie +4 more
doaj
Design of Slag System for FB2 Heat-resistant Steel Electroslag Remelting and Its Effect on Element Loss [PDF]
TeshugangBased on the principle of low eutectic point， a new basic slag system for electric slag remelting of FB2 heat-resistant steel was designed and calculated by FactSage software. The effects of traditional slag system 69.65% CaF2-29.85% Al2O3-0.5% B2O3 （1#）
Li Longfei, Niu Chengzhou, Wang Ning, Wang Chunhui, Lin Tengchang, Zhou Xiaozhou
doaj +1 more source
Dynamic Simulation on Temperature Field of Slab Ingot during Electroslag Remelting
Teshugang, 2007 According to characteristics of electroslag remelting (ESR) of steel, the unsteady-state model for ESR slab ingot has been established to simulate the temperature field of slab ingot during ESR with different remelting speed and analyze the effect ...
常立忠, 李正邦
doaj
Iranian Journal of Materials Science and Engineering, 2014 This study is focused on the effects of electroslag remelting by prefused slag (CaO, Al2O3, and CaF2) on macrostructure and reduction of inclusions in the medical grad of 316LC (316LVM) stainless steel.
S. Ahmadi, H.R. Shahverdi, H. Arabi
doaj
Industrial test of a 6-m long bearing steel ingot by electroslag remelting withdrawing process [PDF]
China Foundry, 2015 In this study, the key technologies of a 6-m long bearing steel ingot produced by electroslag remelting withdrawing (ESRW) process, including bifilar mode supply, slag system development, and design of mold, were studied based on the laboratory research ...
Xi-min Zang, Tian-yu Qiu, Xin Deng
doaj
Optimizing Design of Equipments for an 120 t Large Electroslag Remelting Furnace
Teshugang, 2011 Large-Scale Electroslag Furnace R&D Center, Northeastern University (Shenyang Dongda Xingke Metallurgical Technology Co Ltd) has designed and manufactured a 120-t large electroslag remelting furnace with advanced new idea.
刘喜海 +5 more
doaj
Investigation of fluoride evaporation from CaF2-CaO-Al2O3-MgO-TiO2-(Li2O) slag for electroslag remelting. [PDF]
Sci Rep, 2020 Ju J, Ji G, Tang C, Yang K, Zhu Z.
europepmc +1 more source
Teshugang, 2006 Ti burning loss rate during electroslag remelting(ESR)of alloy 0Cr15Ni25Ti2MoAlVB in a 2.5 t ESR furnace by 4 kinds of slag systems was tested and analyzed.The test results showed that as remelting using 75%CaF2-15%Al2O3-10%CaO pure terary slag the Ti ...
赵鸿燕
doaj