Results 281 to 290 of about 3,312,964 (370)

Investigation of Iron‐Aluminide‐Like Phase Composition in Complex Concentrated Fe32Cu12Ni11Ti16Al29 Alloy

open access: yesAdvanced Engineering Materials, EarlyView.
This work reveals the phase composition and quantitative morphology analysis of precipitation‐hardened Fe32Cu12Ni11Ti16Al29 complex‐concentrated alloy. The precipitates are shown to have a high coherency. Morphology transition between sphere, cuboidal, and elongated morphology is observed. Finally, the overaging behavior is captured using microhardness.
Rostyslav Nizinkovskyi   +4 more
wiley   +1 more source

Reactive Interaction and Wetting of Fe‐ and Mn‐Containing, Secondary AlSi Alloys with Manganese Oxide Ceramic Filter Material for Fe Removal

open access: yesAdvanced Engineering Materials, EarlyView.
Fe‐ and Mn‐containing AlSi alloys undergo aluminothermic reaction with Mn oxide in sessile‐drop and crucible experiments forming poor‐wetting Al2O3 while Mn enriches in the alloy. Primary Fe‐containing particles are preferentially attached to the Mn oxide.
Hanka Becker   +6 more
wiley   +1 more source

Comparative Study of Experimental Methods for Measuring Thermal Properties of 100Cr6 Steel Powders

open access: yesAdvanced Engineering Materials, EarlyView.
This study investigates the thermal properties of 100Cr6 steel in both bulk and powder forms. Measuring the very low thermal conductivity typically exhibited by powders poses significant challenges. To address this, two novel measurement techniques—temperature gradient and finite laser pulse response—are introduced and evaluated by comparison with the ...
Junsheng Zhuo   +8 more
wiley   +1 more source

Efficient and Scalable Radiative Cooling for Photovoltaics Using Solution‐Processable and Solar‐Transparent Mesoporous Nanoparticles

open access: yesAdvanced Functional Materials, EarlyView.
Graded refractive index (GRI) structures are prepared from the layer‐by‐layer spray coating of the mesoporous SiO2 nanoparticles, showing high solar transparency and thermal emissivity. Under outdoor conditions, after 50 days, the GRI‐coated photovoltaics show on average 6.65 ± 1.48 °C lower than that of the non‐coated references, maintaining 80.9 ± 8 ...
Heesuk Jung   +14 more
wiley   +1 more source

Home - About - Disclaimer - Privacy